AM.I.D.S7
SkillFabricate a flexible hose.
From the FAA library
- Chapter 9: Fluid Lines & Fittings › Hose Identification › Fabrication & Replacement of Flexible Hose
Fabrication & Replacement of Flexible Hose To make a hose assembly, select the proper size hose and end fitting. [Figure 9-35] MS-type end fittings for flexible hose are detachable and may be reused if determined to be serviceable…
- Chapter 9: Fluid Lines & Fittings › Introduction
widely used in aircraft for fuel, oil, coolant, oxygen, instrument, and hydraulic lines. Flexible hose is generally used with moving parts or where the hose is subject to considerable vibration. Occasionally, it may be necessary to repair or replace damaged ... made simply by replacing the tubing. However, if replacements are not available, the needed parts may have to be fabricated. Replacement tubing should be of the same size and material as the original tubing. All tubing is pressure tested prior…
- Chapter 9: Fluid Lines & Fittings › Hose Identification › Flexible Hose Inspection
flexible hose equipped with swaged end fittings, the entire assembly must be replaced. Obtain a new hose assembly of the correct size and length, complete with factory installed end fittings. When failure occurs in hose equipped with reusable end fittings ... replacement line can be fabricated with the use of such tooling as may be necessary to comply with the assembly instructions of the manufacturer. Figure 9-33. Hose identification markings…