AM.I.K.S4

From the FAA library

• Aviation Maintenance Technician Handbook - Powerplantp. 8-20
  Chapter 8: Engine Removal & Replacement › Engine Shipping Containers

  Service engine and aircraft in accordance with the manufacturer’s instruction. 7. Thoroughly clean the aircraft and engine. Perform visual inspection. 8. Correct any discrepancies. 9. Conduct a normal engine start. 10. Perform operational test in accordance with operational inspection…

• Aviation Maintenance Technician Handbook - Airframep. 13-28
  Chapter 13: Aircraft Landing Gear Systems › Landing Gear Rigging & Adjustment › Landing Gear Retraction Test

  Landing Gear Retraction Test The proper functioning of a landing gear system and components can be checked by performing a landing gear retraction test. This is also known as swinging the gear. The aircraft is properly supported on jacks ... needed. The gear is then raised and lowered as though the aircraft were in flight while a close visual inspection is performed. All parts of the system should be observed for security and proper operation. The emergency back-up extension…

• Aviation Maintenance Technician Handbook - Airframep. 2-62
  Chapter 2: Aerodynamics, Aircraft Assembly, & Rigging › Annual & 100-Hour Inspections › Preparation

  appliances that are installed. Initial run-up provides an assessment to the condition of the engine prior to performing the inspection. The run-up should include full power and idle rpm, magneto operation, including positive switch grounding, fuel mixture check ... defects that may have been missed because of the dirt. Following in order and using the checklist, visually inspect each item, or perform the checks or tests necessary to verify the condition of the component or system. Record discrepancies when…