AM.II.B.S6
SkillLocate and explain the procedures for tying a modified seine knot.
From the FAA library
- Chapter 5. Air Traffic Procedures › Section 2. Departure Procedures › 5-2-9. Instrument Departure Procedures (DP) - Obstacle Departure Procedures (ODP), Stan…
Instrument Departure Procedures (DP) - Obstacle Departure Procedures (ODP), Standard Instrument Departures (SID), and Diverse Vector Areas (DVA) a. Instrument departure procedures are preplanned instrument flight rule (IFR) procedures which provide obstruction clearance from the terminal area to the appropriate ... route structure. There are two types of DPs, Obstacle Departure Procedures (ODP), printed either textually or graphically, and Standard Instrument Departures (SID), always printed graphically. All DPs, either textual or graphic may be designed using either conventional or RNAV criteria…
- Chapter 1: Aircraft Structures › Maintaining the Aircraft › Location Numbering Systems
Thus, when a blueprint reads “fuselage frame station 137,” that particular frame station can be located 137 inches behind the nose of the aircraft. To locate structures to the right or left of the center line of an aircraft ... aircraft to be a zero station from which measurements can be taken to the right or left to locate an airframe member. This is often used on the horizontal stabilizer and wings. The applicable manufacturer’s numbering system and abbreviated…
- Chapter 4: Engine Ignition & Electrical Systems › Lacing & Tying Wire Bundles
Figure 4-99. Proper mounting angle for cable clamps. Figure 4-100. Typical mounting hardware for cable clamps. Lacing & Tying Wire Bundles Wire groups and bundles are laced or tied with cord to provide ease of installation, maintenance, and inspection ... This section describes and illustrates recommended procedures for lacing and tying wires with knots that hold tightly under all conditions. For the purposes of this discussion, the following terms are defined: 1. Tying is the securing together of a group…