AM.II.F.S16
SkillLocate installation procedures for a seal, backup ring, or gasket.
From the FAA library
- Chapter 12: Hydraulic & Pneumatic Power Systems › Seals › Gaskets
Gaskets Gaskets are used as static (stationary) seals between two flat surfaces. Some of the more common gasket materials are asbestos, copper, cork, and rubber. Asbestos sheeting is used wherever a heat resistant gasket is needed. It is used extensively ... exhaust system gaskets. Most asbestos exhaust gaskets have a thin sheet of copper edging to prolong their life. A solid copper washer is used for spark plug gaskets where it is essential to have a noncompressible, yet semisoft gasket. Cork…
- Chapter 14: Aircraft Fuel Systems › Troubleshooting the Fuel System › Replacement of Gaskets, Seals, & Packings
Replacement of Gaskets, Seals, & Packings A leak can often be repaired by replacing a gasket or seal. When this occurs, or a component is replaced or reassembled after a maintenance operation, a new gasket, seal, or packing must be installed ... Always be sure to use the correct replacement as identified by part number. Also, most gaskets, seals, and packings have a limited shelf life. They should be used only if they are within the service life stamped on the package…
- Chapter 6: Lubrication & Cooling Systems › Engine Cooling Systems › Cylinder Temperature Indicating Systems
Figure 6-59. Gasket type CHT probe. The thermocouple end that connects to the cylinder is either the bayonet or gasket type. To install the bayonet type, the knurled nut is pushed down and turned clockwise until it is snug ... Figure 6-58] In removing this type, the nut is pushed down and turned counterclockwise until released. The gasket type fits under the spark plug and replaces the normal spark plug gasket. [Figure 6-59] When installing a thermocouple lead…