Aviation Mechanic - General, Airframe, and Powerplant › III. Powerplant › Task A. Reciprocating Engines

AM.III.A.S1

Skill

Perform a cylinder assembly inspection.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Aviation Maintenance Technician Handbook - General p. 10-13
Chapter 10: Inspection Concepts & Techniques › Special Inspections
general condition, defects, and insecure attachment. (11) Cowling—for cracks, and defects. (e) Each person performing an annual or 100-hour inspection shall inspect (where applicable) the following components of the landing gear group: (1) All units—for poor condition ... insecure attachment and obvious or apparent defects. (f) Each person performing an annual or 100-hour inspection shall inspect (where applicable) all components of the wing and center section assembly for poor general condition, fabric or skin deterioration, distortion, evidence…
Aviation Maintenance Technician Handbook - Airframe p. 2-62
Chapter 2: Aerodynamics, Aircraft Assembly, & Rigging › Annual & 100-Hour Inspections › Preparation
The manufacturer separates the areas to inspect such as engine, cabin, wing…
Aviation Maintenance Technician Handbook - Powerplant p. 8-2
Chapter 8: Engine Removal & Replacement › Reasons for Removal of Reciprocating Engines › Engine Operational Problems
Turbine Engine Condition Monitoring Programs Many turbine engines are monitored by an engine condition program that helps determine the health of the engine in service. This can also be called trend analysis performance monitoring, but it consists mainly of monitoring ... certain engine parameters daily and watching for trend shifts or changes in the engine parameters. A shift in key parameters (change over time) could be a warning that the engine has serious internal deterioration and should be overhauled. Engine Operational…
Aviation Maintenance Technician Handbook - Powerplant p. 8-17
Chapter 8: Engine Removal & Replacement › Engine Mounts › Mounts for Reciprocating Engines
This stress is torsional and affects all bolts, not just the top bolts. A typical engine mount ring shown in Figure 8-16 discloses fittings and attachment points located at four positions on the engine mount structure. Each fitting houses ... dynamic engine mount. The section of an engine mount where the engine is attached is known as the engine mount ring. It is usually constructed of steel tubing having a larger diameter than the rest of the mount structure…
Aviation Maintenance Technician Handbook - Powerplant p. 6-34
Chapter 6: Lubrication & Cooling Systems › Engine Cooling Systems › Reciprocating Engine Cooling System Maintenance
Reciprocating Engine Cooling System Maintenance The engine cooling system of most reciprocating engines usually consists of the engine cowling, cylinder baffles, cylinder fins, and some use a type of cowl flaps. In addition to these major units, there are also ... some temperature-indicating systems, such as cylinder head temperature, oil temperature, and exhaust gas temperature. The cowling performs two functions: 1. It streamlines the bulky engine to reduce drag. 2. It forms an envelope around the engine that forces…