AM.III.A.S3
SkillInstall piston and knuckle/wrist pin(s).
From the FAA library
- Chapter 1: Aircraft Engines › Pistons › Piston Construction
Piston Construction The majority of aircraft engine pistons are machined from aluminum alloy forgings. Grooves are machined in the outside surface of the piston to receive the piston rings, and cooling fins are provided on the inside of the piston ... greater heat transfer to the engine oil. Pistons may be either the trunk type or the slipper type. [Figure 1-14] Slipper-type pistons are not used in modern, high-powered engines because they do not provide adequate strength…
- 14 CFR Part 135 — Operating Requirements: Commuter and on Demand Operations and Rules Governing Persons on Board Such AircraftOpen14 CFR Part 135, Appendix D to Part 135—Airplane Flight Recorder Specification
Part 135—Airplane Flight Recorder Specification The parameters are listed in order of significance: Drift Angle | When available. As installed | As installed | 4 Wind Speed and Direction | When available. As installed | As installed | 4 Latitude and Longitude | When available ... installed | As installed | 4 Brake pressure/Brake pedal position | As installed | As installed | 1 Additional engine parameters: EPR | As installed | As installed | 1 (per engine) N 1 | As installed | As installed | 1 (per engine) N 2 | As installed | As installed…
- 14 CFR Part 121, Appendix B to Part 121—Airplane Flight Recorder Specification
following parameters is recommended. The parameters are listed in order of significance: Drift Angle | When available, As installed | As installed | 4 Wind Speed and Direction | When available, As installed | As installed | 4 Latitude and Longitude | When available, As installed ... installed | 4 Brake pressure/Brake pedal position | As installed | As installed | 1 Additional engine parameters: EPR | As installed | As installed | 1 (per engine). N1 | As installed | As installed | 1 (per engine). N2 | As installed | As installed | 1 (per engine…