Aviation Mechanic - General, Airframe, and Powerplant › III. Powerplant › Task B. Turbine Engines

AM.III.B.S9

Skill

Locate the installation or removal procedures for a turbine engine.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Aeronautical Information Manual p. PCG C-7
Pilot/Controller Glossary › C
installed at the site of the outer or middle marker of an instrument landing system (ILS). It can be used for navigation at distances of approximately 15 miles or as authorized in the approach procedure. a. Outer Compass Locator ... compass locator installed at the site of the outer marker of an instrument landing system. (See OUTER MARKER.) b. Middle Compass Locator (LMM)- A compass locator installed at the site of the middle marker of an instrument landing system…
Aviation Maintenance Technician Handbook - Airframe p. 11-71
Chapter 11: Communication & Navigation › Installation of Communication & Navigation Equipment › Considerations
controls. Routing of the interconnecting wires, cables, antenna leads, etc. is also an important part of the installation process. When selecting a location for the equipment ... area(s) designated by the airframe manufacturer or the STC. If such information is not available, select a location for installation that will carry the loads imposed by the weight of the equipment, and which is capable of withstanding…
Aviation Maintenance Technician Handbook - Powerplant p. 8-9
Chapter 8: Engine Removal & Replacement › Removing the Engine › Hoisting the Engine
point, maneuver it with the hoist until it slips free. The procedure just discussed applies to removal of most reciprocating and turbine aircraft engines. Any variation in details is outlined in the manufacturer’s instructions. Before attempting any engine removal…