Aviation Mechanic - General, Airframe, and Powerplant › III. Powerplant › Task M. Propellers

AM.III.M.K7

Knowledge

Procedures for removal and installation of a propeller.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Aviation Maintenance Technician Handbook - Powerplant p. 7-26
Chapter 7: Propellers › Propeller Removal & Installation › Removal
Propeller Removal & Installation Removal The following procedure is for demonstration purposes only. Always ... current manufacturer’s information when removing and installing any propeller. 1. Remove the spinner dome in accordance with the spinner removal procedures. Cut and remove the safety wire (if installed) on the propeller mounting studs. 2. Support the propeller assembly…
Aviation Maintenance Technician Handbook - Powerplant p. 7-26
Chapter 7: Propellers › Propeller Balancing › Balancing Procedure
Most equipment use an optical pickup that senses reflective tape for rpm…
Aviation Maintenance Technician Handbook - Powerplant p. 7-28
Chapter 7: Propellers › Servicing Propellers › Propeller Lubrication
propeller. One example of the lubrication requirements and procedures is detailed here for illustration purposes only. Lubrication intervals are important to adhere to because of corrosion implications. The propeller must be lubricated at intervals not to exceed 100 hours ... also result in voids in the blade bearing area where moisture can collect. Remove the lubrication fitting from the cylinder-side hub half installed in the engine-side hub half. [Figure 7-42] Pump 1 fluid ounce (30 milliliters…