CA.III.B.S4
SkillMaintain orientation with the runway/landing area in use.
From the FAA library
- Chapter 14: Airport Operations › Traffic Patterns › Example: Key to Traffic Pattern Operations— Single Runway
Example: Key to Traffic Pattern Operations— Single Runway 1. Enter pattern in level flight, abeam the midpoint of the runway, at pattern altitude. (1,000' AGL is recommended pattern altitude unless otherwise established.) [Figure 14-39] 2. Maintain pattern altitude ... until abeam approach end of the landing runway on downwind leg. [Figure 14-39] 3. Complete turn to final at least ¼ mile from the runway. [Figure 14-39] 4. After takeoff or go-around, continue straight ahead until beyond departure…
- Chapter 8: Airport Traffic Patterns › Standard Airport Traffic Patterns
Figure 8-2. Traffic pattern indicators. Consider the following points when arriving at an airport for landing: ⦁ The pilot should be aware of the appropriate traffic pattern altitude before entering the pattern and remain clear of the traffic flow until ... normally entered at a 45° angle to the downwind leg, headed toward a point abeam the midpoint of the runway to be used for landing. ⦁ The pilot should ensure that the entry leg is of sufficient length to provide…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing
Pilots must not exit the landing runway onto another runway unless authorized by ATC. At airports with an operating control tower, pilots should not stop or reverse course on the runway without first obtaining ATC approval. b. Taxi clear ... runway unless otherwise directed by ATC. An aircraft is considered clear of the runway when all parts of the aircraft are past the runway edge and there are no restrictions to its continued movement beyond the runway holding position markings…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-3. Traffic Patterns
remaining in the traffic pattern, commence turn to crosswind leg beyond the departure end of the runway within 300 feet of pattern altitude. 6. If departing the traffic pattern, continue straight out, or exit with a 45 degree turn ... hand traffic pattern; to the right when in a right-hand traffic pattern) beyond the departure end of the runway, after reaching pattern altitude. Traffic Pattern Operations Parallel Runways EXAMPLE-Key to traffic pattern operations 1. Enter pattern in level…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-11. Pilot Responsibilities When Conducting Land and Hold Short Operations (LAHSO)
pilot-in-command has the final authority to accept or decline any land and hold short clearance. The safety and operation of the aircraft remain the responsibility of the pilot. Pilots are expected to decline a LAHSO clearance if they ... with all available information concerning LAHSO at their destination airport. Pilots should have, readily available, the published ALD and runway slope information for all LAHSO runway combinations at each airport of intended landing. Additionally, knowledge about landing performance data permits…
- 12 OTHER NON-TOWERED AIRPORT AIRCRAFT TRAFFIC PATTERNS › 12.2 Gliders
This runway pattern may be on the opposite side of the runway from fixed-wing traffic only when airspeed requires it or for practice power-off landings and if local policy permits. Landings not on the runway should avoid ... flow of fixed-wing traffic. 12.1.4 Helicopters operating in the traffic pattern when landing on the runway may fly a pattern similar to the fixed-wing aircraft traffic pattern but at a lower altitude (500 feet AGL) and closer…