Commercial Pilot for Airplane Category › IV. Takeoffs, Landings, and Go-Arounds › Task E. Short-Field Takeoff and Maximum Performance Climb (ASEL, AMEL)

CA.IV.E.S12

Skill

Configure the airplane in accordance with the manufacturer’s guidance after a positive rate of climb has been verified.

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Airplane Flying Handbook p. 3-17
Chapter 3: Basic Flight Maneuvers › Climbs and Climbing Turns
Normal climb speed is generally higher than the airplane’s best rate of climb. The additional airspeed provides for better engine cooling, greater control authority, and better visibility over the nose of the airplane. Normal climb is sometimes referred ... cruise climb. ⦁ Best rate of climb (VY)—produces the most altitude gained over a given amount of time. This airspeed is typically used when initially departing a runway without obstructions until it is safe to transition to a normal…
Airplane Flying Handbook p. 6-12
Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb › Initial Climb
rotate to the appropriate pitch attitude at (or near) VX. The pilot should be aware that some airplanes have a natural tendency to lift off well before reaching VX. In these airplanes, it may be necessary to allow the airplane ... lift off in ground effect and then reduce pitch attitude to level until the airplane accelerates to VX with the wheels just clear of the runway surface. This method is preferable to forcing the airplane to remain on the ground…
Airplane Flying Handbook p. 16-17
Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Initial Climb
making a power reduction, the pilot should reduce the pitch attitude simultaneously if needed and monitor the airplane airspeed and rate of climb so as to preclude an inadvertent reduction in desired performance or a descent. Speed is limited ... otherwise authorized by the Administrator (14 CFR part 91, section 91.117(a)). At or above that altitude, the best rate of climb speed is published in the AFM. If asked to increase rate of climb, increasing pitch slightly will have…
Pilot's Handbook of Aeronautical Knowledge p. 11-6
Chapter 11: Aircraft Performance › Performance › Climb Performance
Positive climb performance occurs when an aircraft gains PE by increasing altitude. Two basic factors, or a combination of the two factors, contribute to positive climb performance in most aircraft: 1. The aircraft climbs (gains PE) using excess power above ... that required to maintain level flight, or 2. The aircraft climbs by converting airspeed (KE) to altitude (PE). As an example of factor 1 above, an aircraft with an engine capable of producing 200 horsepower (at a given altitude…
Airplane Flying Handbook p. 6-13
Chapter 6: Takeoffs and Departure Climbs › Soft/Rough-Field Takeoff and Climb › Initial Climb
Initial Climb After a positive rate of climb is established, and the airplane has accelerated to VY, the pilot should retract the landing gear and flaps, if equipped. If departing from an airstrip with wet snow or slush ... event an obstacle needs to be cleared after a soft-field takeoff, the pilot should perform the climb-out at VX until the obstacle has been cleared. The pilot should then adjust the pitch attitude to VY and retract…