CA.IV.M.R2e
Risk managementEffects of:
Landing surface/condition
From the FAA library
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…
- Chapter 9: Approaches and Landings › Final Approach › Wrong Surface Landing Avoidance
airspeed are maintained by integrating pitch and power changes, an untrained or inexperienced pilot may try to reach a landing spot by applying back-elevator pressure without adding power. However, attempting to stretch the final approach by raising the pitch ... excessive rate of descent or a low altitude stall. It is possible for either or both to occur. Wrong Surface Landing Avoidance A wrong surface landing occurs when an aircraft lands or tries to land on the wrong runway…
- Chapter 18: Emergency Procedures › Flight Control Malfunction/Failure › Landing Gear Malfunction
hard surface does, however, create sparks that can ignite fuel. If the airport is so equipped, the pilot can request that the runway surface be foamed. The pilot should consider burning off excess fuel. This reduces landing speed and fire ... potential. If the landing gear malfunction is limited to one main landing gear leg, the pilot should consume as much fuel from that side of the airplane as practicable, thereby reducing the weight of the wing on that side…
- Chapter 9: Approaches and Landings › Emergency Approaches and Landings (Simulated)
Emergency Approaches and Landings (Simulated) During dual training flights, the instructor should give simulated emergency landings by retarding the throttle and calling “simulated emergency landing.” The objective of these simulated emergency landings is to develop a pilot’s accuracy, judgment ... planning, procedures, and confidence when little or no power is available. A simulated emergency landing may be given with the airplane in any configuration. If the simulated power failure occurs while above best glide speed, the pilot allows the airplane…
- Chapter 9: Approaches and Landings › Crosswind Approach and Landing
Common Errors Common errors with forward slips to a landing: 1. Incorrect pitch adjustments that result in poor airspeed control. 2. Reacting to erroneous airspeed indications. 3. Using excess power while trying to lose altitude. 4. A slip ... same direction as any crosswind. 5. Poor glidepath control. 6. Late transition to a sideslip during landing with crosswinds. 7. Landing without the longitudinal axis parallel to runway. 8. Landing off the centerline. Crosswind Approach and Landing Most runways…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Engine Landing › Landing Speeds
Landing Speeds As in the takeoff planning, there are certain speeds that should be taken into consideration when landing a jet airplane. The speeds are as follows: ⦁ VSO —stall speed in the landing configuration. ⦁ VREF —1.3 times the stall speed ... landing configuration. ⦁ Approach climb—the speed that guarantees adequate performance in a go-around situation with an inoperative engine. ⦁ Landing climb—the speed that guarantees adequate performance in arresting the descent and making a go-around from the final stages…