CA.IV.M.R7

From the FAA library

• Airplane Flying Handbookp. 5-17
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Full Stalls, Power-Off

  Full Stalls, Power-Off The practice of power-off stalls is usually performed with normal landing approach conditions to simulate an accidental stall occurring during approach to landing. However, power-off stalls should be practiced at all flap settings ... ensure familiarity with handling arising from mechanical failures, icing, or other abnormal situations. Airspeed in excess of the normal approach speed should not be carried into a stall entry since it could result in an abnormally nose-high attitude…

• Airplane Flying Handbookp. 9-15
  Chapter 9: Approaches and Landings › Intentional Slips › Forward Slip to a Landing

  Forward Slip to a Landing When demonstrating a forward slip to a landing in an airport traffic pattern, the pilot plans the descent such that a forward slip may be used on final approach. Flaps usually remain retracted, and using ... forward slip on downwind or base may be a necessary part of the maneuver. When abeam the landing point on the downwind leg, the pilot initiates a descent by reducing power to idle. If an insufficient rate of descent occurs…

• Airplane Flying Handbookp. 5-17
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Approaches to Stalls (Impending Stalls), Power-On or Power-Off

  Approaches to Stalls (Impending Stalls), Power-On or Power-Off An impending stall occurs when the airplane is approaching, but does not exceed the critical AOA. The purpose of practicing impending stalls is to learn to retain or regain full ... control of the airplane immediately upon recognizing that it is nearing a stall, or that a stall is likely to occur if the pilot does not take appropriate action. Pilot training should emphasize teaching the same recovery technique for impending…

• Airplane Flying Handbookp. 9-26
  Chapter 9: Approaches and Landings › Power-Off Accuracy Approaches › 90° Power-Off Approach

  This helps in planning the turn onto the final approach and provides some indication of when to lower the flaps. At the 45° key position, the throttle is closed completely, the propeller control (if equipped) advanced to the full increase ... revolution per minute (rpm) position, and altitude maintained until the airspeed decreases to the manufacturer’s recommended glide speed. In the absence of a recommended speed, the pilot should use 1.4 VSO. When this airspeed is attained, the nose…

• Airplane Flying Handbookp. 13-19
  Chapter 13: Transition to Multiengine Airplanes › Spin Awareness and Stalls › Power-Off Approach to Stall (Approach and Landing)

  Power-Off Approach to Stall (Approach and Landing) A power-off approach to stall is trained and checked to simulate problematic approach and landing scenarios. A power-off approach to stall may be performed with wings level, or from shallow ... turns (up to 20 degrees of bank). To initiate a power-off approach to stall maneuver, the area surrounding the airplane should first be cleared for possible traffic. The airplane should then be slowed and configured for an approach…