Tutor Platform
Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

Sign in to generate a study note

From the FAA library

  • Chapter 10: Advanced Flight Maneuvers › Slope Operations › Technique

    Refer to Figure 10-6. At the termination of the approach, if necessary, move the helicopter slowly toward the slope, being careful not to turn the tail upslope. Position the helicopter across the slope at a stabilized hover headed into ... touches the ground, hesitate momentarily in a level attitude, then apply slight lateral cyclic in the direction of the slope (frame 2). This holds the skid against the slope while the pilot continues lowering the downslope skid with the collective…

  • Chapter 10: Advanced Flight Maneuvers › Slope Operations

    Slope Operations Prior to conducting any slope operations, be thoroughly familiar with the characteristics of dynamic rollover and mast bumping, which are discussed in Chapter 11, Helicopter Emergencies and Hazards. The approach to a slope is similar to the approach ... other landing area. During slope operations, make allowances for wind, barriers, and forced landing sites in case of engine failure. Since the slope may constitute an obstruction to wind passage, anticipate turbulence and downdrafts. Slope Landing A pilot usually lands…

  • Chapter 11: Helicopter Emergencies and Hazards › Dynamic Rollover › Slope Takeoffs and Landings

    Slope Takeoffs and Landings During slope operations, excessive application of cyclic control into the slope, together with excessive collective pitch control, can result in the downslope skid or landing wheel rising sufficiently to exceed lateral cyclic control limits ... upslope rolling motion can occur. [Figure 11-6] When performing slope takeoff and landing maneuvers, follow the published procedures and keep the roll rates small. Slowly raise the downslope skid or wheel to bring the helicopter level, and then lift…

  • Chapter 10: Advanced Flight Maneuvers › Confined Area Operations

    Common Errors 1. Failing to adjust cyclic control to keep the helicopter from sliding down slope. 2. Failing to maintain proper rpm. 3. Holding excessive cyclic into the slope as the down slope skid is raised. 4. Failure to maintain ... heading, resulting in a turning or pivoting motion. 5. Turning the tail of the helicopter into the slope during takeoff. Confined Area Operations A confined area is an area where the flight of the helicopter is limited in some direction…