CH.V.A.S3
SkillVerify assigned/correct runway, if at an airport.
From the FAA library
- Chapter 7. Safety of Flight › Section 2. Barometric Altimeter Errors and Setting Procedures › 7-3-5. Cold Temperature Airport Procedures
Cold Temperature Airport Procedures a. PILOTS MUST NOT MAKE AN ALTIMETER CHANGE to accomplish an altitude correction. Pilots must ensure that the altimeter is set to the current altimeter setting provided by ATC in accordance with ... Actions on when and where to make corrections: Pilots will make an altitude correction to the published, “at”, “at or above”, and “at or below” altitudes on all designated segment(s) to all runways for all published instrument approach procedures…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-6. Use of Runways/Declared Distances
conducted at the time of landing must fall within the applicable declared distances before the pilot can accept that runway for takeoff or landing. (c) Runway design standards may impose restrictions on the amount of runway available ... takeoff and landing that are not apparent from the reported physical length of the runway or from runway markings and lighting. The runway elements of Runway Safety Area (RSA), Runway Object Free Area (ROFA), and Runway Protection Zone…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-11. Pilot Responsibilities When Conducting Land and Hold Short Operations (LAHSO)
compromise safety. 4. To conduct LAHSO, pilots should become familiar with all available information concerning LAHSO at their destination airport. Pilots should have, readily available, the published ALD and runway slope information for all LAHSO runway combinations at each airport ... intended landing. Additionally, knowledge about landing performance data permits the pilot to readily determine that the ALD for the assigned runway is sufficient for safe LAHSO. As part of a pilot’s preflight planning process, pilots should determine if their…
- Chapter 14: Airport Operations › Stop Bar Lights › New Lighting Technologies
Lighting Technologies A top priority of the FAA is to continue to enhance airport safety while maintaining airport capacity. Reducing runway incursions is a major component of this effort. Runway incursions develop quickly and without warning during routine traffic situations ... airport surface, leaving little time for corrective action. The Runway Status Lights (RWSL) System is designed to provide a direct indication to you that it is unsafe to enter a runway, cross a runway, or takeoff from or land…
- Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 1. Airport Lighting Aids › 2-1-6. Runway Status Light (RWSL) System
will be issued by ATC. 2. What a pilot would observe: A pilot in position to depart from a runway, or has begun takeoff roll, will observe THLs illuminate in reaction to an aircraft or vehicle on the runway ... entering or crossing it. Lights will extinguish when the runway is clear. A pilot may observe several cycles of illumination and extinguishing depending on the amount of crossing traffic. 3. When a pilot observes the red light of the THLs…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing
When issuing taxi instructions to any point other than an assigned takeoff runway, ATC will specify the point to taxi to, issue taxi instructions, and state any hold short instructions or runway crossing clearances if the taxi route will cross ... runway. NOTEATC is required to obtain a readback from the pilot of all runway hold short instructions. 8. If a pilot is expected to hold short of a runway approach/departure (Runway XX APPCH/Runway XX DEP) hold area or ILS holding…