CH.VIII.C.K1

From the FAA library

• Pilot's Handbook of Aeronautical Knowledgep. 2-19
  Chapter 2: Aeronautical Decision-Making › TEAM Checklist: Choose and Implement Risk Controls › The DECIDE Model

  First, adjust the power to the maximum controllable level on both engines. Because the left engine is the only engine delivering thrust, the yaw increases to the right, which necessitates application of additional left rudder application. Figure ... worldwide. Its application is illustrated in column A while automatic/naturalistic decision-making is shown in column B. The failed engine is the side that requires no rudder pressure, in this case the right engine. Second, having identified the failed right…

• Pilot's Handbook of Aeronautical Knowledgep. 11-17
  Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance

  item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…

• Helicopter Flying Handbookp. 10-6
  Chapter 10: Advanced Flight Maneuvers › Shallow Approach and Running/Roll-On Landing

  Shallow Approach and Running/Roll-On Landing Use a shallow approach and running landing when a high-density altitude, a high gross weight condition, or some combination thereof, is such that a normal or steep approach cannot be made because of insufficient ... power to hover. [Figure 10-5] To compensate for this lack of power, a shallow approach and running landing makes use of translational lift until surface contact is made. If flying a wheeled helicopter, a roll-on landing…

• Pilot's Handbook of Aeronautical Knowledgep. 7-2
  Chapter 7: Aircraft Systems › Reciprocating Engines

  These two engine designs can be further classified as: 1. Cylinder arrangement with respect to the crankshaft— radial, in-line, v-type, or opposed 2. Operating cycle—two or four 3. Method of cooling—liquid or air Radial engines were ... widely used during World War II and many are still in service today. With these engines, a row or rows of cylinders are arranged in a circular pattern around the crankcase. The main advantage of a radial engine…

• Helicopter Flying Handbookp. 9-19
  Chapter 9: Basic Flight Maneuvers › Approaches › Technique

  Technique On final approach, at the recommended approach airspeed and at approximately 300 feet AGL, the helicopter should be on the correct ground track (or ground alignment) for the intended landing site, but the axis of the helicopter does ... have to be aligned until about 50-100 feet AGL to facilitate a controlled approach. [Figure 9-20] Just prior to reaching the desired approach angle, begin the approach by lowering the collective sufficiently to get the helicopter decelerating…

• Pilot's Handbook of Aeronautical Knowledgep. 7-21
  Chapter 7: Aircraft Systems › Turbine Engines › Turbofan

  Turboprop A turboprop engine is a turbine engine that drives a propeller through a reduction gear. The exhaust gases drive a power turbine connected by a shaft that drives the reduction gear assembly. Reduction gearing is necessary in turboprop engines ... because optimum propeller performance is achieved at much slower speeds than the engine’s operating rpm. Turboprop engines are a compromise between turbojet engines and reciprocating powerplants. Turboprop engines are most efficient at speeds between…