CP.I.F.R2

From the FAA library

• Pilot's Handbook of Aeronautical Knowledgep. 5-37
  Chapter 5: Aerodynamics of Flight › Load Factors › Rough Air

  speed. Regardless of the speed held, there may be gusts that can produce loads that exceed the load limits. Each specific aircraft is designed with a specific G loading that ... imposed on the aircraft without causing structural damage. There are two types of load factors factored into aircraft design: limit load and ultimate load. The limit load is a force applied to an aircraft that causes a bending…

• Aircraft Weight and Balance Handbookp. G-1
  Glossary

  determine that no condition of legal loading of an aircraft can move the CG outside of its allowable limits. Aircraft specifications. Documentation containing the pertinent specifications for aircraft certificated under the CARs. Airplane Flight manual (AFM). An FAA-approved document ... prepared by the holder of a type certificate for an aircraft, that specifies the operating limitations and contains the required markings and placards and other information applicable to the regulations under which the aircraft was certificated Approved type certificate…

• Pilot's Handbook of Aeronautical Knowledgep. 10-3
  Chapter 10: Weight and Balance › Balance, Stability, and Center of Gravity › Stability

  those mentioned for an excess weight condition. It is vital to comply with weight and balance limits established for all aircraft. Operating above the maximum weight limitation compromises the structural integrity of the aircraft and can adversely affect performance. Stability ... fore and aft limits beyond which the CG should not be located for flight. These limits are published for each aircraft in the Type Certificate Data Sheet (TCDS), or aircraft specification and the AFM or pilot’s operating handbook…

• Pilot's Handbook of Aeronautical Knowledgep. 9-13
  Chapter 10: Weight and Balance

  such as ADs, provide pilots with ready access to pertinent information needed to safely fly a particular aircraft. By understanding the operations, limitations, and performance characteristics of the aircraft, the pilot can make educated flight decisions. By learning what preventive ... essential tools used to reach that goal. Chapter 10: Weight and Balance Compliance with the weight and balance limits of any aircraft is critical to flight safety. Operating above the maximum weight limitation compromises the structural integrity of an aircraft…

• Aircraft Weight and Balance Handbookp. 3-2
  Chapter 3: Weighing the Aircraft and Determining the Empty Weight Center of Gravity › Requirements

  Overloading of the aircraft is not the only concern; the distribution of the weight is important also. The aircraft has CG limits, and any loading that places the CG outside the established limits seriously impairs controllability of the aircraft. Weight ... command (PIC) is responsible for knowing the weight of the load, CG, maximum allowable weight, and CG limits of the aircraft. The weight and balance report must include an equipment list showing weights and moment arms of all required…

• Pilot's Handbook of Aeronautical Knowledgep. 5-38
  Chapter 5: Aerodynamics of Flight › Load Factors › Vg Diagram

  excessive flight loads. The limit airspeed (or redline speed) is a design reference point for the aircraft—this aircraft is limited to 225 mph. If flight is attempted beyond the limit airspeed, structural damage or structural failure may result from ... variety of phenomena. The aircraft in flight is limited to a regime of airspeeds and Gs that do not exceed the limit (or redline) speed, do not exceed the limit load factor, and cannot exceed the maximum lift capability…