CP.II.D.K2

From the FAA library

• Aeronautical Information Manualp. 5-2-2
  Chapter 5. Air Traffic Procedures › Section 2. Departure Procedures › 5-2-5. Line Up and Wait (LUAW)

  Parts 91, 121, 125, and 135 Flightcrew Procedures during Taxi Operations. d. Situational awareness during line up and wait operations is enhanced by monitoring ATC instructions/clearances issued to other aircraft. Pilots should listen carefully if another aircraft is on frequency ... look for aircraft crossing the runway, on final approach, or landing roll (including intersecting runways) prior to and while taxiing onto the runway. ATC should be contacted anytime there is a concern about a potential conflict or clarity is needed…

• Aeronautical Information Manualp. 5-2-1
  Chapter 5. Air Traffic Procedures › Section 2. Departure Procedures › 5-2-1. Pre-taxi Clearance Procedures

  Section 2. Departure Procedures 5-2-1. Pre-taxi Clearance Procedures a. Certain airports have established pre-taxi clearance programs whereby pilots of departing instrument flight rules (IFR) aircraft may elect to receive their IFR clearances before they start taxiing ... takeoff. The following provisions are included in such procedures: 1. Pilot participation is not mandatory. 2. Participating pilots call clearance delivery or ground control not more than 10 minutes before proposed taxi time. 3. IFR clearance (or delay information…

• Aeronautical Information Manualp. 4-3-24
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing

  When issuing taxi instructions to any point other than an assigned takeoff runway, ATC will specify the point to taxi to, issue taxi instructions, and state any hold short instructions or runway crossing clearances if the taxi route will cross ... runway. NOTEATC is required to obtain a readback from the pilot of all runway hold short instructions. 8. If a pilot is expected to hold short of a runway approach/departure (Runway XX APPCH/Runway XX DEP) hold area or ILS holding…

• Aeronautical Information Manualp. 4-3-28
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing

  operating control tower, pilots should not stop or reverse course on the runway without first obtaining ATC approval. b. Taxi clear of the runway unless otherwise directed by ATC. An aircraft is considered clear of the runway when all parts ... there are no restrictions to its continued movement beyond the runway holding position markings. In the absence of ATC instructions, the pilot is expected to taxi clear of the landing runway by taxiing beyond the runway holding position markings associated…

• Aeronautical Information Manualp. 4-3-23
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-17. VFR Helicopter Operations at Controlled Airports

  clearances are in no way intended to place the helicopter in a hazardous position. It is expected that pilots will advise ATC if a specific clearance will cause undue hazards to persons or property. b. Controllers normally limit ATC ground ... service and instruction to movement areas; therefore, operations from nonmovement areas are conducted at pilot discretion and should be based on local policies, procedures, or letters of agreement. In order to maximize the flexibility of helicopter operations, it is necessary…