CP.IV.C.S8
SkillComply with airport/heliport/helipad/landing area markings, lights, signs, and ATC instructions.
From the FAA library
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing
Pilots must not exit the landing runway onto another runway unless authorized by ATC. At airports with an operating control tower, pilots should not stop or reverse course on the runway without first obtaining ATC approval. b. Taxi clear ... runway unless otherwise directed by ATC. An aircraft is considered clear of the runway when all parts of the aircraft are past the runway edge and there are no restrictions to its continued movement beyond the runway holding position markings…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing
Taxiing a. General. Approval must be obtained prior to moving an aircraft or vehicle onto the movement area during the hours an Airport Traffic Control Tower is in operation. 1. Always state your position on the airport when calling ... tower for taxi instructions. 2. The movement area is normally described in local bulletins issued by the airport manager or control tower. These bulletins may be found in FSSs, fixed base operators offices, air carrier offices, and operations offices…
- Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 1. Airport Lighting Aids › 2-1-6. Runway Status Light (RWSL) System
THLs extinguish, this is not clearance to begin a takeoff roll. All takeoff clearances will be issued by ATC. 2. What a pilot would observe: A pilot in position to depart from a runway, or has begun takeoff roll, will ... observe THLs illuminate in reaction to an aircraft or vehicle on the runway or entering or crossing it. Lights will extinguish when the runway is clear. A pilot may observe several cycles of illumination and extinguishing depending on the amount…
- Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 3. Airport Marking Aids and Signs › 2-3-1. General
Lighting Systems Certain light-emitting diode (LED) lighting systems fall outside the combined visible and near-infrared spectrum of night vision goggles (NVGs) and thus will not be visible to a flightcrew using NVGs. The FAA changed specifications ... based red obstruction lights to make them visible to pilots using certain NVG systems, however, other colors may not be visible. It is recommended that air carriers/operators—including part 91 operators—who use NVGs incorporate procedures into manuals and/or standard…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-25. Flight Inspection/‘Flight Check’ Aircraft in Terminal Areas
Strobe lights should not be illuminated during taxi if they will adversely affect the vision of other pilots or ground personnel. f. At the discretion of the pilot-in-command, all exterior lights should be illuminated when taxiing ... across any runway. This increases the conspicuousness of the aircraft to controllers and other pilots approaching to land, taxiing, or crossing the runway. Pilots should comply with any equipment operating limitations and consider the effects of landing and strobe lights…
- Chapter 9: Aircraft Electrical System › Exterior Lights › Landing & Taxi Lights
Each light may be controlled by a relay, or it may be connected directly into the electric circuit. On some aircraft, the landing light is mounted in the same area with a taxi light. [Figure 9-178] A sealed beam ... halogen, or high intensity xenon discharge lamp is used. Taxi lights are designed to provide illumination on the ground while taxiing or towing the aircraft to or from a runway, taxi strip, or in the hangar area. [Figure…