CP.XI.B.S11
SkillUse controls while lowering the downslope landing gear to touchdown.
From the FAA library
- Glossary › Pilot’s Operating Handbook/Airplane Flight Manual
expressed in terms of visibility, distance from cloud, and ceiling meeting or exceeding the minimums specified for VFR. VLE. Landing gear extended speed. The maximum speed at which an airplane can be safely flown with the landing gear extended ... Landing gear operating speed. The maximum speed for extending or retracting the landing gear if using an airplane equipped with retractable landing gear. VMC. Minimum control airspeed. This is the minimum flight speed at which a light, twin-engine airplane…
- Chapter 7: Aircraft Systems › Hydraulic Systems › Fixed and Retractable Landing Gear
Fixed and Retractable Landing Gear Landing gear can also be classified as either fixed or retractable. Fixed landing gear always remains extended and has the advantage of simplicity combined with low maintenance. Retractable landing gear is designed to streamline ... airplane by allowing the landing gear to be stowed inside the structure during cruising flight. [Figure 7-39] Brakes Airplane brakes are located on the main wheels and are applied by either a hand control or by foot pedals…
- Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls
Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…
- Chapter 14: Airport Operations › Airport Markings and Signs › Land and Hold Short Operations (LAHSO)
Land and Hold Short Operations (LAHSO) When simultaneous operations (takeoffs and landings) are being conducted on intersecting runways, Land and Hold Short Operations (LAHSO) may also be in effect. LAHSO is an ATC procedure that may require your participation ... Runway distance remaining sign indicating that there is 2,000 feet of runway remaining. If issued a land and hold short clearance, you must be aware of the reduced runway distances and whether or not you can comply before accepting…
- Chapter 6: Flight Controls › Flight Control Systems › Servo Tabs
airflow striking the tab counterbalances some of the air pressure against the primary control surface and enables the pilot to move the control more easily and hold the control surface in position. If the linkage between the balance ... operation and appearance to the trim tabs previously discussed. A servo tab is a small portion of a flight control surface that deploys in such a way that it helps to move the entire flight control surface in the direction…
- Chapter 14: Airport Operations › Traffic Patterns
Traffic Patterns At airports without an operating control tower, a segmented circle visual indicator system, if installed, is designed to provide traffic pattern information. [Figure 14-38] Usually located in a position affording maximum visibility to pilots ... centralized location for other elements of the system, the segmented circle consists of the following components: wind direction indicators, landing direction indicators, landing strip indicators, and traffic pattern indicators. A tetrahedron is installed to indicate the direction of landings…