FH.VI.B.K3
KnowledgeATC light signal recognition.
From the FAA library
- Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 1. Airport Lighting Aids › 2-1-8. Pilot Control of Airport Lighting
Control of Lighting Systems a. Operation of approach light systems and runway lighting is controlled by the control tower (ATCT). At some locations the FSS may control the lights where there is no control tower in operation. b. Pilots ... request that lights be turned on or off. Runway edge lights, in-pavement lights and approach lights also have intensity controls which may be varied to meet the pilots request. Sequenced flashing lights (SFL) may be turned…
- Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 1. Airport Lighting Aids › 2-1-6. Runway Status Light (RWSL) System
Runway Status Light (RWSL) System a. Introduction. RWSL is a fully automated system that provides runway status information to pilots and surface vehicle operators to clearly indicate when it is unsafe to enter, cross, takeoff from, or land ... runway. The RWSL system processes information from surveillance systems and activates Runway Entrance Lights (REL) and Takeoff Hold Lights (THL), in accordance with the position and velocity of the detected surface traffic and approach traffic…
- Pilot/Controller Glossary › A
ALSF-1- Approach Light System with Sequenced Flashing Lights in ILS Cat-I configuration. 2. ALSF-2- Approach Light System with Sequenced Flashing Lights in ILS Cat-II configuration. The ALSF-2 may operate as an SSALR when weather conditions ... permit. 3. SSALF- Simplified Short Approach Light System with Sequenced Flashing Lights. 4. SSALR- Simplified Short Approach Light System with Runway Alignment Indicator Lights. 5. MALSF- Medium Intensity Approach Light System with Sequenced Flashing Lights. 6. MALSR- Medium Intensity Approach…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-13. Traffic Control Light Signals
Traffic Control Light Signals a. The following procedures are used by ATCTs in the control of aircraft, ground vehicles, equipment, and personnel not equipped with radio. These same procedures will be used to control aircraft, ground vehicles, equipment, and personnel ... equipped with radio if radio contact cannot be established. ATC personnel use a directive traffic control signal which emits an intense narrow light beam of a selected color (either red, white, or green) when controlling traffic by light signals…
- Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 1. Airport Lighting Aids › 2-1-5. In-runway Lighting
Alternate green and yellow lights are installed, beginning with green, from the runway centerline to one centerline light position beyond the runway holding position or ILS critical area holding position. d. Taxiway Centerline Lead-On Lights. Taxiway centerline lead ... lights provide visual guidance to persons entering the runway. These “lead-on” lights are also color-coded with the same color pattern as lead-off lights to warn pilots and vehicle drivers that they are within the runway environment…