FH.VI.C.S1
SkillIdentify and interpret airport/heliport/helipad/landing area runways, taxiways, markings, signs, and lighting.
From the FAA library
- Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 1. Airport Lighting Aids › 2-1-8. Pilot Control of Airport Lighting
Control of Lighting Systems a. Operation of approach light systems and runway lighting is controlled by the control tower (ATCT). At some locations the FSS may control the lights where there is no control tower in operation. b. Pilots ... request that lights be turned on or off. Runway edge lights, in-pavement lights and approach lights also have intensity controls which may be varied to meet the pilots request. Sequenced flashing lights (SFL) may be turned…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-25. Flight Inspection/‘Flight Check’ Aircraft in Terminal Areas
Strobe lights should not be illuminated during taxi if they will adversely affect the vision of other pilots or ground personnel. f. At the discretion of the pilot-in-command, all exterior lights should be illuminated when taxiing ... across any runway. This increases the conspicuousness of the aircraft to controllers and other pilots approaching to land, taxiing, or crossing the runway. Pilots should comply with any equipment operating limitations and consider the effects of landing and strobe lights…
- Chapter 14: Airport Operations › Traffic Patterns › Example: Key to Traffic Pattern Operations— Single Runway
Example: Key to Traffic Pattern Operations— Single Runway 1. Enter pattern in level flight, abeam the midpoint of the runway, at pattern altitude. (1,000' AGL is recommended pattern altitude unless otherwise established.) [Figure 14-39] 2. Maintain pattern altitude ... until abeam approach end of the landing runway on downwind leg. [Figure 14-39] 3. Complete turn to final at least ¼ mile from the runway. [Figure 14-39] 4. After takeoff or go-around, continue straight ahead until beyond departure…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-17. VFR Helicopter Operations at Controlled Airports
Takeoff and Landing Procedures. 1. Helicopter operations may be conducted from a runway, taxiway, portion of a landing strip, or any clear area which could be used as a landing site such as the scene of an accident, a construction ... site, or the roof of a building. The terms used to describe designated areas from which helicopters operate are: movement area, landing/takeoff area, apron/ramp, heliport and helipad (See Pilot/Controller Glossary). These areas may be improved or unimproved…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-13. Traffic Control Light Signals
Traffic Control Light Signals a. The following procedures are used by ATCTs in the control of aircraft, ground vehicles, equipment, and personnel not equipped with radio. These same procedures will be used to control aircraft, ground vehicles, equipment, and personnel ... radio contact cannot be established. ATC personnel use a directive traffic control signal which emits an intense narrow light beam of a selected color (either red, white, or green) when controlling traffic by light signals. b. Although the traffic signal…
- Chapter 8: Airport Traffic Patterns › Standard Airport Traffic Patterns
Figure 8-2. Traffic pattern indicators. Consider the following points when arriving at an airport for landing: ⦁ The pilot should be aware of the appropriate traffic pattern altitude before entering the pattern and remain clear of the traffic flow until ... normally entered at a 45° angle to the downwind leg, headed toward a point abeam the midpoint of the runway to be used for landing. ⦁ The pilot should ensure that the entry leg is of sufficient length to provide…