FH.VII.A.S6

From the FAA library

• Helicopter Flying Handbookp. 9-19
  Chapter 9: Basic Flight Maneuvers › Approaches › Technique

  Technique On final approach, at the recommended approach airspeed and at approximately 300 feet AGL, the helicopter should be on the correct ground track (or ground alignment) for the intended landing site, but the axis of the helicopter does ... have to be aligned until about 50-100 feet AGL to facilitate a controlled approach. [Figure 9-20] Just prior to reaching the desired approach angle, begin the approach by lowering the collective sufficiently to get the helicopter decelerating…

• Helicopter Flying Handbookp. 9-7
  Chapter 9: Basic Flight Maneuvers › Hovering › Technique

  Hovering A stationary hover is a maneuver in which the helicopter is maintained in nearly motionless flight over a reference point at a constant altitude and on a constant heading. Technique To maintain a hover over a point, use sideview ... altitude. When these changes are noted, make the necessary control inputs before the helicopter starts to move from the point. To detect small variations in altitude or position, the main area of visual attention needs to be some distance from…

• Helicopter Flying Handbookp. 9-9
  Chapter 9: Basic Flight Maneuvers › Hovering—Forward Flight › Technique

  Common Errors Failing to maintain a slow, constant rate of turn. 2. Failing to maintain position over the reference point. 3. Failing to maintain rpm within normal range. 4. Failing to maintain constant altitude. 5. Failing to use the antitorque ... location, and it may begin from a stationary hover. During the maneuver, constant groundspeed, altitude, and heading should be maintained. Technique Before starting, pick out two references directly in front and in line with the helicopter. These reference points should…

• Helicopter Flying Handbookp. 10-3
  Chapter 10: Advanced Flight Maneuvers › Maximum Performance Takeoff › Technique

  Normally, this maneuver is initiated from the surface. After checking the area for obstacles and other aircraft, select reference points along the takeoff path to maintain ground track. Also consider alternate routes in case the maneuver is not possible. [Figure ... Begin the takeoff by getting the helicopter light on the skids (position 1). Pause and neutralize all aircraft movement. Slowly increase the collective and position the cyclic to lift off in a 40-knot attitude. This is approximately the same…

• 14 CFR Part 91 — General Operating and Flight RulesOpen
  14 CFR § 91.155 Basic VFR weather minimums.

  Basic VFR weather minimums. 1,000 feet above. 2,000 feet horizontal. Night | 3 statute miles | 500 feet below. 1,000 feet above. 2,000 feet horizontal. More than 1,200 feet above the surface and at or above ... feet MSL | 5 statute miles | 1,000 feet below. 1,000 feet above. 1 statute mile horizontal. (b) Class G Airspace. Notwithstanding the provisions of paragraph (a) of this section, the following operations may be conducted in Class G airspace…

• Helicopter Flying Handbookp. 9-9
  Chapter 9: Basic Flight Maneuvers › Hovering—Sideward Flight › Technique

  Then, pick two points of in-line reference in the direction of sideward hovering flight to help maintain the proper ground track. These reference points should be kept in line throughout the maneuver. [Figure 9-8] Begin the maneuver from ... normal hovering height by applying cyclic toward the side in which the movement is desired. As the movement begins, return the cyclic toward the neutral position to maintain low groundspeed—no faster than a brisk walk. Throughout the maneuver, maintain…