FH.VII.C.S6
SkillComply with airport/heliport/helipad/landing area markings, lights, signs, and ATC instructions.
From the FAA library
- Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 1. Airport Lighting Aids › 2-1-8. Pilot Control of Airport Lighting
Control of Lighting Systems a. Operation of approach light systems and runway lighting is controlled by the control tower (ATCT). At some locations the FSS may control the lights where there is no control tower in operation. b. Pilots ... request that lights be turned on or off. Runway edge lights, in-pavement lights and approach lights also have intensity controls which may be varied to meet the pilots request. Sequenced flashing lights (SFL) may be turned…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-25. Flight Inspection/‘Flight Check’ Aircraft in Terminal Areas
Strobe lights should not be illuminated during taxi if they will adversely affect the vision of other pilots or ground personnel. f. At the discretion of the pilot-in-command, all exterior lights should be illuminated when taxiing ... across any runway. This increases the conspicuousness of the aircraft to controllers and other pilots approaching to land, taxiing, or crossing the runway. Pilots should comply with any equipment operating limitations and consider the effects of landing and strobe lights…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing
Taxiing a. General. Approval must be obtained prior to moving an aircraft or vehicle onto the movement area during the hours an Airport Traffic Control Tower is in operation. 1. Always state your position on the airport when calling ... tower for taxi instructions. 2. The movement area is normally described in local bulletins issued by the airport manager or control tower. These bulletins may be found in FSSs, fixed base operators offices, air carrier offices, and operations offices…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing
Pilots must not exit the landing runway onto another runway unless authorized by ATC. At airports with an operating control tower, pilots should not stop or reverse course on the runway without first obtaining ATC approval. b. Taxi clear ... runway unless otherwise directed by ATC. An aircraft is considered clear of the runway when all parts of the aircraft are past the runway edge and there are no restrictions to its continued movement beyond the runway holding position markings…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-17. VFR Helicopter Operations at Controlled Airports
Takeoff and Landing Procedures. 1. Helicopter operations may be conducted from a runway, taxiway, portion of a landing strip, or any clear area which could be used as a landing site such as the scene of an accident, a construction ... site, or the roof of a building. The terms used to describe designated areas from which helicopters operate are: movement area, landing/takeoff area, apron/ramp, heliport and helipad (See Pilot/Controller Glossary). These areas may be improved or unimproved…
- Chapter 9: Aircraft Electrical System › Exterior Lights › Landing & Taxi Lights
Each light may be controlled by a relay, or it may be connected directly into the electric circuit. On some aircraft, the landing light is mounted in the same area with a taxi light. [Figure 9-178] A sealed beam ... halogen, or high intensity xenon discharge lamp is used. Taxi lights are designed to provide illumination on the ground while taxiing or towing the aircraft to or from a runway, taxi strip, or in the hangar area. [Figure…