FH.VII.E.S4
SkillMaintain powerplant and main rotor(s) (Nr) speed within normal limits.
From the FAA library
- Chapter 2: Aerodynamics of Flight › Hovering Flight › Translating Tendency (Drift)
Translating Tendency (Drift) During hovering flight, a single main rotor helicopter tends to move in the direction of tail rotor thrust. This lateral (or sideward) movement is called translating tendency. [Figure 2-27] To counteract this tendency, one or more ... following features may be used. All examples are for a counterclockwise rotating main rotor disk. Figure 2-27. A tail rotor is designed to produce thrust in a direction opposite torque. The thrust produced by the tail rotor is sufficient…
- Chapter 1: Introduction to the Helicopter › Rotor System › Tandem Rotor
Tandem Rotor Tandem rotor (sometimes referred to as dual rotor) helicopters have two large horizontal rotor assemblies, instead of one main assembly and a smaller tail rotor. [Figure 1-6] Single rotor helicopters need a tail rotor to neutralize ... twisting momentum produced by the single large rotor. Tandem rotor helicopters, however, use counter-rotating rotors, each canceling out the other’s torque. Counter-rotating rotor blades will not collide with and destroy each other if they flex into…
- Chapter 5: Rotorcraft Flight Manual › Operating Limitations (Section 2) › Rotor Limitations
Altitude Limitations If the rotorcraft has a maximum operating density altitude (see page 7-2), it is indicated in this section of the flight manual. Sometimes the maximum altitude varies based on different gross weights. Rotor Limitations Low rpm does ... produce sufficient lift, and high rpm may cause structural damage, therefore rotor rpm limitations have minimum and maximum values. A green arc depicts the normal operating range with red lines showing the minimum and maximum limits. [Figure 5-3] There…
- Chapter 11: Helicopter Emergencies and Hazards › System Malfunctions › Loss of Tail Rotor Effectiveness (LTE)
catastrophic. LTE is an aerodynamic condition and is the result of a control margin deficiency in the tail rotor. It can affect all single-rotor helicopters that utilize a tail rotor. The design of main and tail rotor blades ... will not nullify the phenomenon entirely. Translational lift is obtained by any amount of clean air through the main rotor disk. Chapter 2, Aerodynamics of Flight, discusses translational lift with respect to the main rotor blade, explaining that the more…
- Chapter 2: Aerodynamics of Flight › Turning Flight
Figure 2-45. Forces acting on the helicopter during turning flight. Autorotation is the state of flight where the main rotor disk of a helicopter is being turned by the action of air moving up through the rotor rather than ... engine power driving the rotor. In normal, powered flight, air is drawn into the main rotor disk from above and exhausted downward, but during autorotation, air moves up into the rotor disk from below as the helicopter descends. Autorotation…
- Chapter 9: Basic Flight Maneuvers › The Four Fundamentals › Guidelines
Good practices to follow during maneuvering flight include: 1. Move the cyclic only as fast as trim, torque, and rotor speed can be maintained. When entering a maneuver and the trim, rotor, or torque reacts quicker than anticipated, pilot limitations ... have been exceeded. If continued, an aircraft limitation will be exceeded. Perform the maneuver with less intensity until all aspects of the machine can be controlled. The pilot must be aware of the sensitivity of the flight controls…