FH.VIII.F.S9
SkillAnalyze and correct common errors related to this Task.
From the FAA library
- Chapter 11: Helicopter Emergencies and Hazards › Autorotation › Common Errors
landing carriage, slowing the helicopter; however, this is dependent on the condition of the landing surface. One common error is the holding of the helicopter off the surface, versus cushioning it onto the surface during an autorotation. Holding the helicopter ... surface for a controlled, smooth landing instead of allowing the helicopter to drop the last few inches. Common Errors 1. Not understanding the importance of an immediate entry into autorotation upon powerplant or driveline failure. 2. Failing to use sufficient…
- Chapter 2: Aerodynamics of Flight › Airflow and Reactions in the Rotor Disk › Resultant Relative Wind
highest. As blade speed decreases nearer the center of the disk, downward velocity is less. Figure 2-19. Rotational relative wind. Resultant Relative Wind The resultant relative wind at a hover is rotational relative wind modified by induced flow. This ... inclined downward at some angle and opposite the effective flightpath of the airfoil, rather than the physical flightpath (rotational relative wind). The resultant relative wind also serves as the reference plane for development of lift, drag, and total aerodynamic force…
- Chapter 2: Aerodynamics of Flight › Airflow and Reactions in the Rotor Disk › Rotational Relative Wind (Tip-Path Plane)
Airflow and Reactions in the Rotor Disk Relative Wind Knowledge of relative wind is essential for an understanding of aerodynamics and its practical flight application for the pilot. Relative wind is airflow relative to an airfoil. Movement of an airfoil ... through the air creates relative wind. Relative wind moves in a direction parallel to but opposite of the movement of the airfoil. [Figure 2-15] There are two parts to wind passing a rotor blade: • Horizontal part—caused…
- Chapter 9: Basic Flight Maneuvers › Approaches › Common Errors
Common Errors 1. Failing to maintain proper rpm during the entire approach. 2. Improper use of the collective in controlling the angle of descent. 3. Failing to make antitorque pedal corrections to compensate for collective changes during the approach…
- Chapter 3: The Learning Process › Kinds of Errors › Slip
Errors Errors are a natural part of human performance. Beginners, as well as the most highly skilled experts, are vulnerable to error, and this is perhaps the most important thing to understand about error. To believe people can eliminate errors ... from their performance is to commit the biggest error of all. Instructors and learners alike should be prepared for occasional errors by learning about common kinds of errors, how errors can be minimized, how to learn from errors…
- Chapter 7, Section I: Airplane Basic Flight Maneuvers › Turns › Steep Turns
During training in steep turns, as in any other maneuver, attend to the most important tasks first. Keep the pitch attitude relatively constant, and more time can be devoted to cross-check and instrument interpretation. During recovery from steep turns ... released and power decreased. The common errors associated with steep turns are the same as those discussed later in this section. Remember, errors are more exaggerated, more difficult to correct, and more difficult to analyze unless rates of entry…