FH.VIII.G.S2

From the FAA library

• Pilot's Handbook of Aeronautical Knowledgep. 6-2
  Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls

  Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…

• Helicopter Flying Handbookp. 1-6
  Chapter 1: Introduction to the Helicopter › Controlling Flight › Throttle

  Throttle Helicopter rotors are designed to operate at a specific rpm. Figure 1-11. The throttle control mounted at the end of the collective control. The throttle controls the power produced by the engine, which is connected to the rotor ... transmission. The purpose of the throttle is to maintain enough engine power to keep the rotor rpm within allowable limits to produce enough lift for flight. In single-engine helicopters, if so equipped, the throttle control is typically a twist…

• Pilot's Handbook of Aeronautical Knowledgep. 6-2
  Chapter 6: Flight Controls

  addition, in some large and fast aircraft, controls are boosted by hydraulically or electrically actuated systems. In both the fly-by-wire and boosted controls, the feel of the control reaction is fed back to the pilot by simulated means ... Current research at the National Aeronautics and Space Administration (NASA) Dryden Flight Research Center involves Intelligent Flight Control Systems (IFCS). The goal of this project is to develop an adaptive neural network-based flight control system. Applied directly to flight…

• Helicopter Flying Handbookp. 3-3
  Chapter 3: Helicopter Flight Controls › Cyclic Pitch Control

  Cyclic Pitch Control The cyclic pitch control (or simply “cyclic”) is usually projected upward from the cockpit floor, between the pilot’s legs or between the two pilot seats in some models. [Figure 3-4] This primary flight control allows ... Aerodynamics of Flight, the total lift force is always perpendicular to the tip-path plane of the main rotor. The purpose of the cyclic pitch control is to tilt the tip-path plane in the direction of the desired horizontal…

• Helicopter Flying Handbookp. 11-3
  Chapter 11: Helicopter Emergencies and Hazards › Autorotation › RPM Control

  RPM Control Rotor rpm in low inertia rotor systems has been studied in simulator flight evaluations which indicate that the simultaneous application of aft cyclic, down collective, and alignment with the relative wind (trim) at a wide range of airspeeds ... entering an autorotation may vary with specific makes and/or models of helicopters. A basic discussion of the aerodynamics and control inputs for single rotor systems is in order here. Helicopter pilots must understand the use of the collective for rotor…

• Aviation Instructor's Handbookp. 9-8
  Chapter 9: Techniques of Flight Instruction › Positive Exchange of Flight Controls › Procedure

  Procedure During flight training, there should always be a clear understanding between learners and flight instructors about who has control of the aircraft. The preflight briefing should include procedures for the exchange of flight controls. A positive three-step process ... exchange of flight controls between pilots is a proven procedure and one that is strongly recommended. When an instructor is teaching a maneuver to a learner, the instructor normally demonstrates the maneuver first, then has the learner follow along…