FH.XI.C.S2
SkillMaintain, prior to beginning the final approach segment, the recommended flight profile with altitude ±200 feet, airspeed, ±20 knots, heading ±10°, and maintain track.
From the FAA library
- Chapter 9: Basic Flight Maneuvers › Approaches › Technique
Technique On final approach, at the recommended approach airspeed and at approximately 300 feet AGL, the helicopter should be on the correct ground track (or ground alignment) for the intended landing site, but the axis of the helicopter does ... have to be aligned until about 50-100 feet AGL to facilitate a controlled approach. [Figure 9-20] Just prior to reaching the desired approach angle, begin the approach by lowering the collective sufficiently to get the helicopter decelerating…
- Chapter 9: Techniques of Flight Instruction › Postflight Evaluation › First Solo Flight
First Solo Flight During the learner’s first solo flight, the instructor needs to be present to assist in answering questions or resolving any issues that arise during the flight. To ensure the solo flight is a positive, confidence-building ... experience for the learner, the flight instructor needs to consider time of day when scheduling the flight. Time of day is a factor in traffic congestion, possible winds, sun angles, and reflection. If possible, the flight instructor needs access…
- Chapter 10: Advanced Flight Maneuvers › Steep Approach › Technique
Technique On final approach, maintain track with the intended touchdown point and into the wind as much as possible at the recommended approach airspeed [Figure 10-4, position 1]. When intercepting an approach angle of 13° to 15°, begin ... approach by lowering the collective sufficiently to start the helicopter descending down the approach path and decelerating (position 2). Use the proper antitorque pedal for trim. Since this angle is steeper than a normal approach angle, reduce the collective more…
- Appendix B: Acronyms, Abbreviations, and NOTAM Contractions
federal FEIS—Final Environmental Impact Statement FEP—front end processor FFAC—from facility FI/P—flight inspection permanent FI/T—flight inspection temporary FIFO—Flight Inspection Field Office FIG—flight inspection group FINO—Flight Inspection National Field Office FIPS—federal information publication ... standard FIR—flight information region FIRE—fire station FIRMR—Federal Information Resource Management Regulation FL—flight level FLOWSIM—traffic flow planning simulation FM—from FMA—final monitor aid FMF—facility master file FMIS—FTS2000 management information system FMS—flight management…
- Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls
Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness to control inputs while allowing a natural feel…
- Chapter 9: Techniques of Flight Instruction › Practical Flight Instructor Strategies
Practical Flight Instructor Strategies During all phases of flight training, instructors should remember that individuals learn through observing others; therefore, the instructor needs to model safe and professional behavior. The flight instructor should demonstrate good operational sense at all times ... Before the flight—discuss safety and the importance of a proper preflight and use of the checklist. ⦁ During flight—prioritize the tasks of aviating, navigating, and communicating. Instill importance of aircraft control, “see and avoid,” situational awareness, and workload management…