FH.XI.F.K2g
KnowledgeSystem and equipment malfunctions specific to the helicopter-simplified flight controls, including:
Hydraulic failure, if applicable
From the FAA library
- Chapter 11: Helicopter Emergencies and Hazards › Recovery Technique (Uncontrolled Right Yaw) › Hydraulic Failure
Hydraulic Failure Many helicopters incorporate the use of hydraulic actuators to overcome high control forces. A hydraulic system consists of actuators, also called servos, on each flight control; a pump, which is usually driven by the main rotor transmission ... reservoir to store the hydraulic fluid. A switch in the cockpit can turn the system off, although it is left on during normal conditions. A pressure indicator in the cockpit may be installed to monitor the system. An impending hydraulic…
- Chapter 4: Helicopter Components, Sections, and Systems › Hydraulics
Hydraulics Most helicopters, other than smaller piston-powered helicopters, incorporate the use of hydraulic actuators to overcome high control forces. [Figure 4-25] A typical hydraulic system consists of actuators, also called servos, on each flight control, a pump which ... usually driven by the main rotor transmission and a reservoir to store the hydraulic fluid. Some helicopters have accumulators located on the pressure side of the hydraulic system. This allows for a continuous fluid pressure into the system. A switch…
- Chapter 11: Helicopter Emergencies and Hazards › System Malfunctions › Antitorque System Failure
following the manufacturer’s recommendations regarding operating limits and procedures and periodic maintenance and inspections, many system and equipment failures can be eliminated. Certain malfunctions or failures can be traced to some error on the part of the pilot; therefore ... appropriate flying techniques and use of threat and error management may help to prevent an emergency Antitorque System Failure Antitorque failure usually falls into one of two categories. One is failure of the power drive portion of the tail rotor…
- Appendix C: Certificates, Ratings, and Endorsements › Flight Instructor Endorsements › Sport Pilot
basic requirements. Forms 8710-1, 8610-2, and 8710-11 are versions of the Airman Certificate and/or Rating Application. The instructor should ensure the applicant is prepared for the test and has met all the regulatory requirements, including knowledge, proficiency ... required endorsements, and experience requirements before the application process. The applicant then either completes the 8710 or 8610 paper form by hand or uses the Integrated Airman Certification and Rating Application (IACRA) electronic application system available at iacra.faa.gov/IACRA/Default.aspx. Whenever…
- Chapter 9: Techniques of Flight Instruction › Assessment of Piloting Ability › Practical Test Recommendations
Practical Test Recommendations Provision is made on the airman certificate or rating application form for the written recommendation of the flight instructor who has prepared the applicant for the practical test involved. Signing this recommendation imposes a serious responsibility ... flight instructor. A flight instructor who makes a practical test recommendation for an applicant seeking a certificate or rating should require the applicant to thoroughly demonstrate the knowledge and skill level required for that certificate or rating. This demonstration should…
- 14 CFR § 121.344 Digital flight data recorders for transport category airplanes.
Digital flight data recorders for transport category airplanes. (69) Brake pedal application (left and right); (70) Yaw or sideslip angle (when an information source is installed); (71) Engine bleed valve position (when an information source is installed); (72) De-icing ... status; (76) APU bleed valve position (when an information source is installed); (77) Hydraulic pressure (each system); (78) Loss of cabin pressure; (79) Computer failure; (80) Heads-up display (when an information source is installed); (81) Para-visual display (when…