IH.VII.B.R6

From the FAA library

• Pilot's Handbook of Aeronautical Knowledgep. 11-17
  Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance

  item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…

• Pilot's Handbook of Aeronautical Knowledgep. 2-19
  Chapter 2: Aeronautical Decision-Making › TEAM Checklist: Choose and Implement Risk Controls › The DECIDE Model

  First, adjust the power to the maximum controllable level on both engines. Because the left engine is the only engine delivering thrust, the yaw increases to the right, which necessitates application of additional left rudder application. Figure ... worldwide. Its application is illustrated in column A while automatic/naturalistic decision-making is shown in column B. The failed engine is the side that requires no rudder pressure, in this case the right engine. Second, having identified the failed right…

• Pilot's Handbook of Aeronautical Knowledgep. 7-21
  Chapter 7: Aircraft Systems › Turbine Engines › Turboshaft

  Turboshaft The fourth common type of jet engine is the turboshaft. [Figure 7-26] It delivers power to a shaft that drives something other than a propeller. The biggest difference between a turbojet and turboshaft engine is that ... turboshaft engine, most of the energy produced by the expanding gases is used to drive a turbine rather than produce thrust. Many helicopters use a turboshaft gas turbine engine. In addition, turboshaft engines are widely used as auxiliary power units…

• Airplane Flying Handbookp. 13-30
  Chapter 13: Transition to Multiengine Airplanes › Low Altitude Engine Failure Scenarios › Landing Gear Control Selected Up, Single-Engine Climb Performance Inadequate

  Landing Gear Control Selected Up, Single-Engine Climb Performance Inadequate When operating near or above the single-engine ceiling and an engine failure is experienced shortly after lift-off, a landing needs to be accomplished on whatever essentially lies ahead ... Figure 13-19] There is also the option of continuing ahead, in a descent at VYSE with the remaining engine producing power, as long as the pilot is not tempted to remain airborne beyond the airplane’s performance capability. Remaining…

• Airplane Flying Handbookp. 13-34
  Chapter 13: Transition to Multiengine Airplanes › Engine Inoperative Approach and Landing

  performance variations caused by engine and propeller wear, turbulence, and pilot technique, the airplane may not maintain altitude even at its published single-engine ceiling. Any further rate of sink, however, would likely be modest. An engine failure ... descent or other low power setting can be deceiving. The dramatic yaw and performance loss is absent. At very low power settings, the pilot may not even be aware of a failure. If a failure is suspected, the pilot should…

• Airplane Flying Handbookp. 13-33
  Chapter 13: Transition to Multiengine Airplanes › Low Altitude Engine Failure Scenarios › Checklist

  landing gear should remain selected down as long as there is usable runway or overrun available to land on. The use of wing flaps for takeoff virtually eliminates the likelihood of a single-engine climb until the flaps are retracted ... There are two time-tested memory aids the pilot may find useful in dealing with engine-out scenarios. The first, “dead foot—dead engine” is used to assist in identifying the failed engine. Depending on the failure mode, the pilot…