IR.VII.C.S9
SkillOn final approach segment, maintain vertical (as applicable) and lateral guidance within ¾-scale deflection.
From the FAA library
- Chapter 4: Approaches › Final Approach Segment
Final Approach Segment The final approach segment for an approach with vertical guidance or a precision approach begins where the glideslope/glidepath intercepts the minimum glideslope/ glidepath intercept altitude shown on the approach chart. If ATC authorizes a lower intercept altitude ... final approach segment begins upon glideslope/glidepath interception at that altitude. For a non-precision approach, the final approach segment begins either at a designated FAF, which is depicted as a cross on the profile view, or at the point where…
- Chapter 4: Approaches › Approach Control
Approach Control Approach control is responsible for controlling all instrument flights operating within its area of responsibility. Approach control may serve one or more airports. Control is exercised primarily through direct pilot and controller communication and airport surveillance radar ... Prior to arriving at the initial approach fix (IAF), instructions will be received from the air route traffic control center (ARTCC) to contact approach control on a specified frequency. Where radar is approved for approach control service, it is used…
- Chapter 9: Approaches and Landings › Faulty Approaches and Landings › High Final Approach
sudden decrease in lift and causes the airplane to sink more rapidly. If there is any doubt about the approach being safely completed, it is advisable to execute an immediate go-around. Figure 9-30. Right and wrong methods ... correction for low final approach. High Final Approach When the final approach is too high, the pilot may lower the flaps as required. Further reduction in power may be necessary, while lowering the nose simultaneously to maintain approach airspeed…
- Chapter 3: Arrivals › Radar Vectors to Final Approach Course
that ATC is not able to inform the aircraft, the pilot is not expected to turn inbound on the final approach course unless an approach clearance has been issued. An example of ATC phraseology in this case is, “… expect vectors ... across final for spacing.” The following ATC arrival instructions are issued to an IFR aircraft before it reaches the approach gate: 1. Position relative to a fix on the final approach course. If none is portrayed on the controller…
- Chapter 10: IFR Flight › Approaches › Approach to an Airport With an Operating Tower, With an Approach Control
altitude/flight levels are issued as required for spacing and separating aircraft; do not deviate from the headings issued by approach control. 4. Aircraft are normally informed when it becomes necessary to be vectored across the final approach course for spacing ... other reasons. If approach course crossing is imminent and the pilot has not been informed that the aircraft will be vectored across the final approach course, the pilot should query the controller. The pilot is not expected to turn inbound…
- Chapter 9: Approaches and Landings › Normal Approach and Landing › Final Approach
drift correction is established and maintained to follow a ground track perpendicular to the extension of the landing runway centerline. This requires that the airplane be angled sufficiently into the wind to prevent drifting farther away from the intended landing ... spot. Figure 9-3. Base leg and final approach. Final Approach After the base-to-final approach turn is completed, the pilot aligns the longitudinal axis of the airplane with the centerline of the runway or landing surface…