Sport Pilot for Helicopter - Simplified Flight Controls › IV. Hovering Maneuvers › Task D. Taxiing with Wheel-Type Landing Gear

SH.IV.D.S8

Skill

Position the helicopter-simplified flight controls relative to hold lines or a specified point.

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Aeronautical Information Manual p. 5-4-68
Chapter 5. Air Traffic Procedures › Section 5. Pilot/Controller Roles and Responsibilities › 5-5-1. General
specified if nonstandard. Pilots may be requested to report “break” if required for traffic or other reasons. PHRASEOLOGYBREAK AT (specified point). REPORT BREAK. FIG 5-4-34 Overhead Maneuver Section 5. Pilot/Controller Roles and Responsibilities 5-5-1. General…
Aeronautical Information Manual p. PCG H-2
Pilot/Controller Glossary › H
specified location, identified by visual or other means, in the vicinity of which the position of an aircraft in flight is maintained in accordance with air traffic control clearances. HOLDING PROCEDURE- (See HOLD PROCEDURE.) HOLD-SHORT POINT- A point ... point may be located prior to an intersecting runway, taxiway, predetermined point, or approach/departure flight path. HOLD-SHORT POSITION LIGHTS- Flashing in-pavement white lights located at specified hold-short points. HOLD-SHORT POSITION MARKING- The painted runway marking located…
Aeronautical Information Manual p. 5-6-3
Chapter 5. Air Traffic Procedures › Section 6. National Security and Interception Procedures › 5-6-4. ADIZ Requirements
passing each designated reporting point or those reporting points specified or requested by ATC, except that while the aircraft is under radar control, only the passing of those reporting points specifically requested by ATC need be reported…
Aeronautical Information Manual p. 4-3-24
Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing
When issuing taxi instructions to any point other than an assigned takeoff runway, ATC will specify the point to taxi to, issue taxi instructions, and state any hold short instructions or runway crossing clearances if the taxi route will cross…
Instrument Procedures Handbook p. 3-19
Chapter 3: Arrivals › Altitude
altitude) until specified point (e.g., abeam landing runway end), cleared for visual approach or expect visual or contact approach clearance in (number of miles, minutes, or specified point).” Figure 3-16. Assigned altitudes. Once the determination is made regarding…