SH.V.E.S5
SkillNotify/coordinate with evaluator instructions as required.
From the FAA library
- Chapter 1: Introduction To Flying › Selecting a Flight School › Student Pilot Solo Requirements
Student Pilot Solo Requirements Once a student has accrued sufficient training and experience, a CFI can endorse the student’s logbook to authorize limited solo flight in a specific type (make and model) of aircraft. A student pilot ... aircraft outside of the various endorsements provided by the flight instructor. There is no minimum aeronautical knowledge or experience requirement for the issuance of a Student Pilot Certificate, however, the applicant must be at least 16 years…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing
When issuing taxi instructions to any point other than an assigned takeoff runway, ATC will specify the point to taxi to, issue taxi instructions, and state any hold short instructions or runway crossing clearances if the taxi route will cross ... runway. NOTEATC is required to obtain a readback from the pilot of all runway hold short instructions. 8. If a pilot is expected to hold short of a runway approach/departure (Runway XX APPCH/Runway XX DEP) hold area or ILS holding…
- Chapter 15: Airspace › Air Traffic Control and the National Airspace System › Operating Rules and Pilot/Equipment Requirements
recreational pilot certificate and all requirements contained within 14 CFR part 61, section 61.101(d), or the requirements for a student pilot seeking a recreational pilot certificate in 14 CFR part 61, section 61.94. 3. A sport pilot certificate ... requirements contained within 14 CFR part 61, section 61.325, or the requirements for a student pilot seeking a recreational pilot certificate in 14 CFR part 61, section 61.94, or the aircraft is operated by a student pilot…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing
there are no restrictions to its continued movement beyond the runway holding position markings. In the absence of ATC instructions, the pilot is expected to taxi clear of the landing runway by taxiing beyond the runway holding position markings associated ... with the landing runway, even if that requires the aircraft to protrude into or cross another taxiway or ramp area. Once all parts of the aircraft have crossed the runway holding position markings, the pilot must hold unless further instructions…
- Chapter 10. Helicopter Operations › Section 1. Helicopter IFR Operations › 10-1-1. Helicopter Flight Control Systems
order to be certificated for IFR operation, a specific helicopter may require the use of one or more of these systems, in any combination. d. In many cases, helicopters are certificated for IFR operations with either one or two pilots ... Certain equipment is required to be installed and functional for two pilot operations, and typically, additional equipment is required for single pilot operation. These requirements are usually described in the limitations section of the Rotorcraft Flight Manual…
- Chapter 11. Unmanned Aircraft Systems (UAS) › Section 5. UAS Pilot Testing, Certification and Responsibilities › 11-5-3. Pilot Certification for 14 CFR part 135, Part 137, and Large Civil UAS
updated recurrent training (the online training) to operate at night or over people. 11-5-2. Pilot Certification and Requirements for Public Aircraft Operations (PAOs) a. When operating as a PAO, the operator is required to train and the agency ... Pilot Certification for 14 CFR part 135, Part 137, and Large Civil UAS a. Currently, FAA regulations require a commercial pilot certificate for 14 CFR part 135 Remote PICs. b. Pilot certification for 14 CFR part 137. For civil…