AA.II.E.S4
SkillDetermine airspeeds/V-speeds and set flight instruments appropriately, configure flight director, autopilot, and navigation and communication equipment for the current flight conditions and takeoff and departure clearances.
From the FAA library
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance
Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Rejected Takeoff
takeoff and climb-out should be accomplished in accordance with a standard takeoff and departure profile developed for the particular make and model airplane. [Figure 16-13] Figure 16-13. Sample takeoff and departure profile. The pilot not flying should ... call out V1. After passing V1 speed on the takeoff roll, it is no longer mandatory for the pilot flying to keep a hand on the thrust levers. The point for abort has passed, and both hands may be placed…
- Chapter 6: Takeoffs and Departure Climbs › Normal Takeoff › Takeoff Roll
pilot should also ensure that the takeoff surfaces are firm and of sufficient length to permit the airplane to gradually accelerate to normal lift-off and climb-out speed, and there are no obstructions along the takeoff path. There ... reasons for making a takeoff as nearly into the wind as possible. First, since the airplane depends on airspeed, a headwind provides some of that airspeed even before the airplane begins to accelerate into the wind. Second, a headwind decreases…
- Chapter 6: Takeoffs and Departure Climbs › Crosswind Takeoff › Takeoff Roll
Crosswind Takeoff While it is usually preferable to take off directly into the wind whenever possible or practical, there are many instances when circumstances or judgment indicate otherwise. Therefore, the pilot must be familiar with the principles and techniques involved ... crosswind takeoffs, as well as those for normal takeoffs. A crosswind affects the airplane during takeoff much as it does during taxiing. With this in mind, the pilot should be aware that the technique used for crosswind correction during takeoffs…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › V-Speeds
Airplane Takeoff and Climb The following information is generic in nature and, since most civilian jet airplanes require a minimum flight crew of two pilots, assumes a two-pilot crew. If any of the following information conflicts with FAA-approved ... center or pilot school curriculum, the FAA-approved procedures for that operator and/or training center/pilot school take precedence. V-Speeds The following are speeds that affect the jet airplane’s takeoff performance. The jet airplane pilot should understand…
- 14 CFR § 91.1069 Flight crew: Instrument proficiency check requirements.
Flight crew: Instrument proficiency check requirements. The instrument approach procedure or procedures must include at least one straight-in approach, one circling approach, and one missed approach. Each type of approach procedure demonstrated must be conducted to published minimums ... that procedure. (d) The instrument proficiency checks required by paragraphs (a) and (b) of this section consists of either an oral or written equipment test (or a combination) and a flight check under simulated or actual IFR conditions. The equipment…