AA.III.C.K2

From the FAA library

• Airplane Flying Handbookp. 6-11
  Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb

  possible during the ground run and lift-off, using ground effect as an aid, prior to attaining true flying speed. The pilot should reduce AOA to attain normal airspeed before attempting to fly out of the ground effect areas. Short ... Field Takeoff and Maximum Performance Climb When performing takeoffs and climbs from fields where the takeoff area is short or the available takeoff area is restricted by obstructions, the pilot should operate the airplane at the maximum limit…

• Airplane Flying Handbookp. 6-13
  Chapter 6: Takeoffs and Departure Climbs › Soft/Rough-Field Takeoff and Climb › Initial Climb

  Initial Climb After a positive rate of climb is established, and the airplane has accelerated to VY, the pilot should retract the landing gear and flaps, if equipped. If departing from an airstrip with wet snow or slush ... takeoff surface, the gear should not be retracted immediately so that any wet snow or slush can be air-dried. In the event an obstacle needs to be cleared after a soft-field takeoff, the pilot should perform the climb…

• Airplane Flying Handbookp. 16-17
  Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Initial Climb

  making a power reduction, the pilot should reduce the pitch attitude simultaneously if needed and monitor the airplane airspeed and rate of climb so as to preclude an inadvertent reduction in desired performance or a descent. Speed is limited ... Administrator (14 CFR part 91, section 91.117(a)). At or above that altitude, the best rate of climb speed is published in the AFM. If asked to increase rate of climb, increasing pitch slightly will have the desired effect…

• Pilot's Handbook of Aeronautical Knowledgep. 11-15
  Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance

  Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…

• Airplane Flying Handbookp. 16-14
  Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Rejected Takeoff

  takeoff and climb-out should be accomplished in accordance with a standard takeoff and departure profile developed for the particular make and model airplane. [Figure 16-13] Figure 16-13. Sample takeoff and departure profile. The pilot not flying should ... call out V1. After passing V1 speed on the takeoff roll, it is no longer mandatory for the pilot flying to keep a hand on the thrust levers. The point for abort has passed, and both hands may be placed…

• Airplane Flying Handbookp. 16-12
  Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Takeoff Roll

  speed used during certification at which the critical engine is assumed to fail. ⦁ VR —rotation speed, or speed at which the rotation of the airplane is initiated to takeoff attitude. This speed cannot be less than V1 or less than ... VMCA (minimum control speed in the air). On a single-engine takeoff, it also allows for the acceleration to V2 at the 35-foot height at the end of the runway. ⦁ VLOF —lift-off speed, or speed at which…