AA.III.C.S8
SkillAvoid excessive water spray on the propeller(s).
From the FAA library
- SKIPPING › GLASSY WATER TAKEOFFS
GLASSY WATER TAKEOFFS Glassy water makes takeoff more difficult in two ways. The smoothness of the surface has the effect of increasing drag, making acceleration and lift-off more difficult. This can feel as if there is suction between ... water and the floats. A little surface roughness actually helps break the contact between the floats and the water by introducing turbulence and air bubbles between water and the float bottoms. The intermittent contact between floats and water…
- LANDING › GLASSY WATER LANDING
GLASSY WATER LANDING Flat, calm, glassy water certainly looks inviting and may give the pilot a false sense of safety. By its nature, glassy water indicates no wind, so there are no concerns about which direction to land, no crosswind ... consider, no weathervaning, and obviously no rough water. Unfortunately, both the visual and the physical characteristics of glassy water hold potential hazards for complacent pilots. Consequently, this surface condition is frequently more dangerous than it appears for a landing seaplane…
- RULES OF THE SEA › INLAND AND INTERNATIONAL WATERS
Coast Guard (USCG) regulations, the definition of a vessel includes virtually anything capable of being used for transportation on water, including seaplanes on the water. Therefore, any time a seaplane is operating on the water, whether under power ... Printing Office. These rules apply to all public or private vessels navigating upon the high seas and certain inland waters. INLAND AND INTERNATIONAL WATERS Inland waters are divided visually from international waters by buoys in areas with frequent ocean traffic…
- Chapter 7: Aircraft Systems › Fixed-Pitch Propeller
Small aircraft are equipped with either one of two types of propellers: fixed-pitch or adjustable-pitch. Figure 7-6. Changes in propeller blade angle from hub to tip. Fixed-Pitch Propeller A propeller with fixed blade angles ... fixed-pitch propeller. The pitch of this propeller is set by the manufacturer and cannot be changed. Since a fixed-pitch propeller achieves the best efficiency only at a given combination of airspeed and rpm, the pitch setting is ideal…
- PREFLIGHT INSPECTION
Figure 4-3. Be suspicious if pumping does not remove a small amount of water. If the bilge pump tube is damaged, there may be water in the compartment that the pump cannot remove. At the stern of the float ... check the aft bulkhead, or transom. This area is susceptible to damage from the water rudder moving beyond its normal range of travel. Carefully check the skin for any pinholes or signs of damage from contact with the water rudder…
- Chapter 15: Ice & Rain Protection › Water & Waste Tank Ice Prevention
also used on windshields. Whether alone or part of a TKSTM system or similar, the liquid chemical is sprayed through a nozzle onto the outside of the windshield which prevents ice from forming. The chemical can also deice the windshield ... reservoir, pump, control valve, filter, and relief valve. Other components may exist. Figure 15-46 shows a set of spray tubes for application of chemical anti-ice on an aircraft windshield. Water & Waste Tank Ice Prevention Transport type aircraft have…