AA.III.G.S14

From the FAA library

• Airplane Flying Handbookp. 6-13
  Chapter 6: Takeoffs and Departure Climbs › Soft/Rough-Field Takeoff and Climb › Initial Climb

  needs to be cleared after a soft-field takeoff, the pilot should perform the climb-out at VX until the obstacle has been cleared. The pilot should then adjust the pitch attitude to VY and retract the gear and flaps ... cross-check engine instruments for indications of proper operation after applying power. ⦁ Poor directional control. ⦁ Climbing too high after lift-off and not levelng off low enough to maintain ground effect attitude. ⦁ Abrupt and/or excessive elevator control while attempting…

• Airplane Flying Handbookp. 5-9
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight

  warning—5 to 10 knots above the 1G stall speed is a good target. ⦁ Performing slow flight in configurations appropriate to takeoffs, climbs, descents, approaches to landing, and go-arounds. Slow flight should be introduced with the target airspeed sufficiently ... above the stall to permit safe maneuvering, but close enough to the stall warning for the pilot to experience the characteristics of flight at a low airspeed. One way to determine the target airspeed is to slow the aircraft…

• Pilot's Handbook of Aeronautical Knowledgep. 11-6
  Chapter 11: Aircraft Performance › Performance › Climb Performance

  Positive climb performance occurs when an aircraft gains PE by increasing altitude. Two basic factors, or a combination of the two factors, contribute to positive climb performance in most aircraft: 1. The aircraft climbs (gains PE) using excess power above ... that required to maintain level flight, or 2. The aircraft climbs by converting airspeed (KE) to altitude (PE). As an example of factor 1 above, an aircraft with an engine capable of producing 200 horsepower (at a given altitude…

• Airplane Flying Handbookp. 3-17
  Chapter 3: Basic Flight Maneuvers › Climbs and Climbing Turns

  Normal climb speed is generally higher than the airplane’s best rate of climb. The additional airspeed provides for better engine cooling, greater control authority, and better visibility over the nose of the airplane. Normal climb is sometimes referred ... cruise climb. ⦁ Best rate of climb (VY)—produces the most altitude gained over a given amount of time. This airspeed is typically used when initially departing a runway without obstructions until it is safe to transition to a normal…

• Airplane Flying Handbookp. 3-20
  Chapter 3: Basic Flight Maneuvers › Climbs and Climbing Turns › Climbing Turns

  pitch attitude should be decreased smoothly and slowly to allow for the airspeed to increase. A loss of altitude may result if the pitch attitude is changed too rapidly without allowing the airspeed to increase proportionately. After the airplane ... established in level flight at a constant altitude, climb power should be retained temporarily so that the airplane accelerates to the cruise airspeed. When the airspeed reaches the desired cruise airspeed, the throttle setting and the propeller control, if equipped…

• Airplane Flying Handbookp. 16-17
  Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Initial Climb

  Initial Climb Once the proper pitch attitude is attained, the pilot should maintain it. Takeoff power is also maintained and the airspeed allowed to accelerate. Landing gear retraction should be accomplished after a positive rate of climb has been established ... confirmed. In some airplanes gear retraction may temporarily increase the airplane drag while landing gear doors open. Premature gear retraction may cause the airplane to settle back toward the runway surface. In addition, the vertical speed indicator and the altimeter…