AA.III.I.K2

From the FAA library

• Airplane Flying Handbookp. 16-14
  Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Rejected Takeoff

  takeoff and climb-out should be accomplished in accordance with a standard takeoff and departure profile developed for the particular make and model airplane. [Figure 16-13] Figure 16-13. Sample takeoff and departure profile. The pilot not flying should ... call out V1. After passing V1 speed on the takeoff roll, it is no longer mandatory for the pilot flying to keep a hand on the thrust levers. The point for abort has passed, and both hands may be placed…

• Pilot's Handbook of Aeronautical Knowledgep. 11-15
  Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance

  Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…

• Airplane Flying Handbookp. 6-6
  Chapter 6: Takeoffs and Departure Climbs › Crosswind Takeoff › Takeoff Roll

  Crosswind Takeoff While it is usually preferable to take off directly into the wind whenever possible or practical, there are many instances when circumstances or judgment indicate otherwise. Therefore, the pilot must be familiar with the principles and techniques involved ... crosswind takeoffs, as well as those for normal takeoffs. A crosswind affects the airplane during takeoff much as it does during taxiing. With this in mind, the pilot should be aware that the technique used for crosswind correction during takeoffs…

• Airplane Flying Handbookp. 6-11
  Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb › Takeoff Roll

  Takeoff Roll Taking off from a short field requires the takeoff to be started from the very beginning of the takeoff area. At this point, the airplane is aligned with the intended takeoff path. If the airplane manufacturer recommends ... flaps, they are extended the proper amount before beginning the takeoff roll. This allows the pilot to devote full attention to the proper technique and the airplane’s performance throughout the takeoff. The pilot should apply takeoff power smoothly…

• Airplane Flying Handbookp. 16-12
  Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Takeoff Roll

  pilot not flying. Retarding a thrust lever would only be necessary in case an engine exceeds any limitation. Takeoff data, including V1/VR and V2 speeds, takeoff power settings, and required field length should be computed prior to each takeoff ... make and model without an FMS, the data should be recorded on a takeoff data card. This data is based on airplane weight, runway length available, runway gradient, field temperature, field barometric pressure, wind, icing conditions, and runway condition. Both…

• 14 CFR Part 121 — Operating Requirements: Domestic, Flag, and Supplemental OperationsOpen
  14 CFR Part 121, Appendix F to Part 121—Proficiency Check Requirements

  nontransport category airplanes | B (e) Rejected. A rejected takeoff may be performed in an airplane during a normal takeoff run after reaching a reasonable speed determined by giving due consideration to aircraft characteristics, runway length, surface conditions, wind direction ... velocity, brake heat energy, and any other pertinent factors that may adversely affect safety or the airplane | B* | W III. Instrument procedures: (a) Area departure and area arrival. During each of these maneuvers the pilot must…