AA.III.J.K4

From the FAA library

• Airplane Flying Handbookp. 9-10
  Chapter 9: Approaches and Landings › Go-Arounds (Rejected Landings)

  Arounds (Rejected Landings) A go-around is a normal maneuver that is used when approach and landing parameters deviate from expectations or when it is hazardous to continue. Situations such as air traffic control (ATC) requirements, unexpected appearance of hazards ... runway, overtaking another airplane, wind shear, wake turbulence, mechanical failure, or an unstable approach are all reasons to discontinue a landing approach. Like any other normal maneuver, the go-around should be practiced and perfected. The flight instructor should emphasize…

• Aeronautical Information Manualp. 4-3-19
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-11. Pilot Responsibilities When Conducting Land and Hold Short Operations (LAHSO)

  Land and Hold Short of a Designated Point on a Runway Other Than an Intersecting Runway or Taxiway 5. If, for any reason, such as difficulty in discerning the location of a LAHSO intersection, wind conditions, aircraft condition ... pilot elects to request to land on the full length of the runway, to land on another runway, or to decline LAHSO, a pilot is expected to promptly inform air traffic, ideally even before the clearance is issued. A LAHSO…

• Seaplane, Skiplane, and Float/Ski Equipped Helicopter Operations Handbookp. 7-7
  LANDINGS

  LANDINGS Landing a skiplane is easy compared to landing with wheels; however, for off-airport landings, extra precautions are necessary. Be careful in choosing a landing site. Before landing, evaluate the site to be sure a safe departure will ... possible. Upon arriving at a prospective landing site, a pass should be made over the landing area to determine landing direction, and to determine if a safe approach and landing can be completed. A trial landing should be accomplished…

• Pilot's Handbook of Aeronautical Knowledgep. 11-17
  Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance

  item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…

• Seaplane, Skiplane, and Float/Ski Equipped Helicopter Operations Handbookp. 6-8
  LANDING › EMERGENCY LANDING

  AROUND Whenever landing conditions are not satisfactory, execute a go-around. Potential conflicts with other aircraft, surface vessels or swimmers in the landing area, recognition of a hazard on the water, wind shear, wake turbulence, water surface conditions, mechanical failure ... unstabilized landing approach are a few of the reasons to discontinue a landing attempt. Climb to a safe altitude while executing the go-around checklist, then evaluate the situation, and make another approach under more favorable conditions. Remember that…

• Airplane Flying Handbookp. 9-4
  Chapter 9: Approaches and Landings › Final Approach › Wrong Surface Landing Avoidance

  This is one reason for performing approaches with partial power; if the approach is too high, the pilot can lower the nose and reduce the power to maintain the correct airspeed. When the approach is too low, the pilot ... airspeed are maintained by integrating pitch and power changes, an untrained or inexperienced pilot may try to reach a landing spot by applying back-elevator pressure without adding power. However, attempting to stretch the final approach by raising the pitch…