AA.IV.C.S1

From the FAA library

• Pilot's Handbook of Aeronautical Knowledgep. 1-23
  Chapter 1: Introduction To Flying › Who Administers the FAA Practical Tests? › Role of the Certificated Flight Instructor

  training includes airmanship skills, pilot judgment and decision-making, and good operating practices. A pilot training program depends on the quality of the ground and flight instruction the student pilot receives. The flight instructor must possess a thorough understanding ... student pilot. Use of a structured training program and formal course syllabus is crucial for effective and comprehensive flight training. It should be clear to the student in advance of every lesson what the course of training will involve…

• Risk Management Handbookp. 6-3
  Chapter 6: Threat and Error Management › Defenses Provided to the Pilot or Crew › Checklists, Standard Operating Procedures, and Best Practices

  Defenses against Threats, Errors, and Undesired Aircraft States When a pilot perceives a flight condition that requires attention, the pilot may know what to do immediately or may need time to process alternatives. The pilot may utilize several different strategies ... manage risk while in the air. Defenses Provided to the Pilot or Crew A manufacturer, employer, or a flight school may provide defenses to pilots. Examples include checklists, operating limitations, minimum pilot qualifications, standard operating procedures, and insurance requirements. Regardless…

• Airplane Flying Handbookp. 1-16
  Chapter 1: Introduction to Flight Training › Safety Considerations › Use of Checklists

  Before takeoff ⦁ After takeoff ⦁ Cruise ⦁ Descent ⦁ Before landing ⦁ After landing ⦁ Engine shutdown and securing Figure 1-17. A sample checklist used by pilots. During flight training, there should be a clear understanding between the learner and flight instructor ... control of the aircraft. Prior to any flight, a briefing should be conducted that includes the procedures for the exchange of flight controls. The following three-step process for the exchange of flight controls is highly recommended. When a flight…

• Airplane Flying Handbookp. 3-6
  Chapter 3: Basic Flight Maneuvers › Straight-and-Level Flight › Straight Flight

  Straight Flight Maintaining a constant direction or heading is accomplished by visually checking the relationship of the airplane’s wingtips to the natural horizon. Depending on whether the airplane is a high wing or low wing, both wingtips should ... pilot should understand that anytime the wings are banked, the airplane turns. The objective of straight flight is to detect and correct small deviations, necessitating minor flight control corrections. The bank attitude information can also be obtained from a quick…

• Airplane Flying Handbookp. 3-5
  Chapter 3: Basic Flight Maneuvers › Integrated Flight Instruction

  throttle in most general aviation (GA) airplanes and is used when the flight situation requires a specific thrust setting or for a change in thrust to meet a specific objective. ⦁ Trim control—used to relieve the control pressures held ... pilot on the flight controls after a desired attitude has been attained. Note: Yaw control is used to cancel out the effects of yaw-induced changes, such as adverse yaw and effects of the propeller. Integrated Flight Instruction When introducing…

• Aeronautical Information Manualp. 5-1-10
  Chapter 5. Air Traffic Procedures › Section 1. Preflight › 5-1-5. Flight Plan - VFR Flights

  Flight Plan - VFR Flights (See Appendix 4, FAA Form 7233-4 – International Flight Plan) a. The requirements for the filing and activation of VFR flight plans can vary depending in which airspace the flight is operating. Pilots are responsible ... activating flight plans with a Flight Service Station. Control tower personnel do not automatically activate VFR flight plans. 1. Within the continental U.S., a VFR flight plan is not normally required. 2. VFR flights (except for DoD and law enforcement…