AA.V.B.K6

From the FAA library

• Airplane Flying Handbookp. 5-9
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight

  pilot training and testing purposes, slow flight includes two main elements: ⦁ Slowing to, maneuvering at, and recovering from an airspeed at which the airplane is still capable of maintaining controlled flight without activating the stall warning—5 to 10 knots ... above the 1G stall speed is a good target. ⦁ Performing slow flight in configurations appropriate to takeoffs, climbs, descents, approaches to landing, and go-arounds. Slow flight should be introduced with the target airspeed sufficiently above the stall to permit…

• Airplane Flying Handbookp. 5-11
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight › Maneuvering in Slow Flight

  practical test. With an AOA just under the AOA which may cause an aerodynamic buffet or stall warning, the flight controls are less effective. [Figure 5-7] The elevator control is less responsive and larger control movements are necessary ... retain control of the airplane. In propeller-driven airplanes, torque, slipstream effect, and P-factor may produce a strong left yaw, which requires right rudder input to maintain coordinated flight. The closer the airplane is to the 1G stall…

• Airplane Flying Handbookp. 5-11
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight › Performing the Slow Flight Maneuver

  cases, practicing slow flight should be conducted at an adequate height above the ground for recovery should the airplane inadvertently stall. To begin the slow flight maneuver, the pilot should clear the area and gradually reduce thrust from cruise power ... adjust the pitch to allow the airspeed to decrease while maintaining altitude. As the speed of the airplane decreases, there is a change in the sound of the airflow. As the speed approaches the target slow flight speed, which…

• Airplane Flying Handbookp. 5-16
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Stall Training

  both power-on and power-off stalls is important because it simulates stall conditions that could occur during normal flight maneuvers. It is important for pilots to understand the possible flight scenarios in which a stall could occur. Stall accidents ... usually result from an inadvertent stall at a low altitude, with the recovery not completed prior to ground contact. For example, power-on stalls are practiced to develop the pilot’s awareness of what could happen if the airplane…

• Airplane Flying Handbookp. 3-2
  Chapter 3: Basic Flight Maneuvers › Effect and Use of Flight Controls

  With the pilot’s hand: ⦁ When pulling the elevator pitch control toward the pilot, which is an aft movement of the control wheel, yoke, control stick, or side stick controller (referred to as adding back pressure), the airplane’s nose ... airplane. Think of this movement from the pilot’s feet to the pilot’s head. ⦁ When pushing elevator pitch control toward the instrument panel, (referred to as increasing forward pressure), the airplane rotates the nose forward relative to the pilot…

• 14 CFR Part 61 — Certification: Pilots, Flight Instructors, and Ground InstructorsOpen
  14 CFR § 61.51 Pilot logbooks.

  Pilot logbooks. (iii) Simulated instrument conditions in flight, a full flight simulator, flight training device, or aviation training device. (iv) Use of night vision goggles in an aircraft in flight, in a full flight simulator, or in a flight training ... certificate or rating issued under this part or a privilege authorized under this part; or (2) Satisfy the recent flight experience requirements of this part. (d) Logging of solo flight time. Except for a student pilot performing the duties…