AA.V.B.R1

From the FAA library

• Airplane Flying Handbookp. 5-19
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Accelerated Stalls

  Accelerated Stalls While pilots may understand the cause of an accelerated stall, it takes training to experience how these stalls develop and occur. The objectives of demonstrating an accelerated stall are to determine the stall characteristics of the airplane, experience ... stalls at speeds greater than the +1G stall speed, and develop the ability to instinctively recover at the onset of such stalls. This is a maneuver only commercial pilot and flight instructor applicants may be required to perform…

• Stall and Spin Awareness Trainingp. 5
  CHAPTER 1. GROUND TRAINING: STALL AND SPIN AWARENESS › 104. TYPES OF STALLS

  TYPES OF STALLS. Stalls can be practiced both with and without power. Stalls should be practiced to familiarize the student with the aircraft’s particular stall characteristics without putting the aircraft into a potentially dangerous condition. In multiengine airplanes, single ... engine stalls must be avoided. Descriptions of some different types of stalls follows: a. Power-off stalls (also known as approach-to-landing stalls) are practiced to simulate normal approach-to-landing conditions and configuration. Many stall/spin accidents have occurred…

• Airplane Flying Handbookp. 5-12
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Stall Recognition

  Indications of a full stall are typically that an uncommanded nose down pitch cannot be readily arrested, and may be accompanied by an uncommanded rolling motion. For airplanes equipped with stick pushers, their activation is also an indicator ... full stall. Although it depends on the degree to which a stall has progressed, some loss of altitude is expected during recovery. The longer it takes for the pilot to recognize an impending stall, the more likely it is that…

• Pilot's Handbook of Aeronautical Knowledgep. 5-34
  Chapter 5: Aerodynamics of Flight › Load Factors › Load Factors and Stalling Speeds

  Load Factors and Stalling Speeds Any aircraft, within the limits of its structure, may be stalled at any airspeed. When a sufficiently high AOA is imposed, the smooth flow of air over an airfoil breaks up and separates, producing ... abrupt change of flight characteristics and a sudden loss of lift, which results in a stall. A study of this effect has revealed that an aircraft’s stalling speed increases in proportion to the square root of the load factor…

• Airplane Flying Handbookp. 5-12
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls

  Stalls A stall is an aerodynamic condition which occurs when smooth airflow over the airplane’s wings is disrupted, resulting in loss of lift. Specifically, a stall occurs when the AOA—the angle between the chord line of the wing ... attitude, and at any power setting. [Figure 5-8] Figure 5-8. Critical angle of attack and stall. For these reasons, it is important to understand factors and situations that can lead to a stall, and develop proficiency in stall…