Airline Transport Pilot and Type Rating for Airplane Category › V. Stall Prevention › Task B. Clean Configuration Stall Prevention

AA.V.B.R6

Risk management

Effect of environmental elements on aircraft performance while in cruise flight as it relates to stalls (e.g., turbulence, microbursts, and high-density altitude).

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Airplane Flying Handbook p. 5-12
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Stall Recognition
Indications of a full stall are typically that an uncommanded nose down pitch cannot be readily arrested, and may be accompanied by an uncommanded rolling motion. For airplanes equipped with stick pushers, their activation is also an indicator ... full stall. Although it depends on the degree to which a stall has progressed, some loss of altitude is expected during recovery. The longer it takes for the pilot to recognize an impending stall, the more likely it is that…
Airplane Flying Handbook p. 5-19
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Accelerated Stalls
Accelerated Stalls While pilots may understand the cause of an accelerated stall, it takes training to experience how these stalls develop and occur. The objectives of demonstrating an accelerated stall are to determine the stall characteristics of the airplane, experience ... stalls at speeds greater than the +1G stall speed, and develop the ability to instinctively recover at the onset of such stalls. This is a maneuver only commercial pilot and flight instructor applicants may be required to perform…
Stall and Spin Awareness Training p. 11
CHAPTER 2. FLIGHT TRAINING: STALLS › 200. STALL TRAINING › f. Stalls During Go-Arounds
Cross Controlled Stalls in Gliding Turns. Perform stalls in gliding turns to simulate turns from base to final. Perform the stalls from a properly coordinated turn, a slipping turn, and a skidding turn. Explain the difference between slipping and skidding ... turns. Explain the ball indicator position in each turn and the aircraft behavior in each of the stalls. e. Power-Off (Approach-To-Landing) Stalls (1) Have the student perform a full-flap, gear-extended, power-off stall with…
Airplane Flying Handbook p. 5-9
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight
Slow Flight Flying at reduced airspeeds is normal in the takeoff/departure and approach/landing phases of flight. While pilots typically perform these operations at low airspeeds and close to the ground, pilots learn to maneuver an airplane in slow flight ... safe altitude. During slow flight, any further increase in angle of attack, increase in load factor, or reduction in power, will result in a stall warning (e.g., aircraft buffet, stall horn, etc.), and pilots should react to and correct…
Airplane Flying Handbook p. 5-16
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Stall Training
Stall Training Practice in both power-on and power-off stalls is important because it simulates stall conditions that could occur during normal flight maneuvers. It is important for pilots to understand the possible flight scenarios in which a stall ... could occur. Stall accidents usually result from an inadvertent stall at a low altitude, with the recovery not completed prior to ground contact. For example, power-on stalls are practiced to develop the pilot’s awareness of what could happen…