Airline Transport Pilot and Type Rating for Airplane Category › V. Stall Prevention › Task C. Landing Configuration Stall Prevention

AA.V.C.K1

Knowledge

Aerodynamics associated with stalls in the landing configuration, including the relationship between angle of attack, airspeed, load factor, power setting, aircraft weight and balance, aircraft attitude, and sideslip effects.

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Airplane Flying Handbook p. 5-17
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Full Stalls, Power-Off
Full Stalls, Power-Off The practice of power-off stalls is usually performed with normal landing approach conditions to simulate an accidental stall occurring during approach to landing. However, power-off stalls should be practiced at all flap settings ... ensure familiarity with handling arising from mechanical failures, icing, or other abnormal situations. Airspeed in excess of the normal approach speed should not be carried into a stall entry since it could result in an abnormally nose-high attitude…
Pilot's Handbook of Aeronautical Knowledge p. 11-17
Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…
Airplane Flying Handbook p. 5-18
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Full Stalls, Power-On
Full Stalls, Power-On Power-on stall recoveries are practiced from straight climbs and climbing turns (15° to 20° bank) to help the pilot recognize the potential for an accidental stall during takeoff, go around, climb, or when trying ... clear an obstacle. Airplanes equipped with flaps or retractable landing gear should normally be in the takeoff configuration; however, power-on stalls should also be practiced with the airplane in a clean configuration (flaps and gear retracted) to ensure practice…
Stall and Spin Awareness Training p. 5
CHAPTER 1. GROUND TRAINING: STALL AND SPIN AWARENESS › 104. TYPES OF STALLS
TYPES OF STALLS. Stalls can be practiced both with and without power. Stalls should be practiced to familiarize the student with the aircraft’s particular stall characteristics without putting the aircraft into a potentially dangerous condition. In multiengine airplanes, single ... engine stalls must be avoided. Descriptions of some different types of stalls follows: a. Power-off stalls (also known as approach-to-landing stalls) are practiced to simulate normal approach-to-landing conditions and configuration. Many stall/spin accidents have occurred…
Pilot's Handbook of Aeronautical Knowledge p. 5-34
Chapter 5: Aerodynamics of Flight › Load Factors › Load Factors and Stalling Speeds
Load Factors and Stalling Speeds Any aircraft, within the limits of its structure, may be stalled at any airspeed. When a sufficiently high AOA is imposed, the smooth flow of air over an airfoil breaks up and separates, producing ... abrupt change of flight characteristics and a sudden loss of lift, which results in a stall. A study of this effect has revealed that an aircraft’s stalling speed increases in proportion to the square root of the load factor…