AA.VI.E.S12
SkillMaintain a stabilized final approach from the Final Approach Fix (FAF) to DA/DH allowing no more than ¼-scale deflection of either the vertical or lateral guidance indications and maintain the desired airspeed ±5 knots.
From the FAA library
- Chapter 4: Approaches › Final Approach Segment
Final Approach Segment The final approach segment for an approach with vertical guidance or a precision approach begins where the glideslope/glidepath intercepts the minimum glideslope/ glidepath intercept altitude shown on the approach chart. If ATC authorizes a lower intercept altitude ... final approach segment begins upon glideslope/glidepath interception at that altitude. For a non-precision approach, the final approach segment begins either at a designated FAF, which is depicted as a cross on the profile view, or at the point where…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-3. Approach Control
When radar handoffs are utilized, successive arriving flights may be handed off to approach control with radar separation in lieu of vertical separation. (b) After release to approach control, aircraft are vectored to the final approach course (ILS, RNAV ... issued as required for spacing and separating aircraft. Therefore, pilots must not deviate from the headings issued by approach control. Aircraft will normally be informed when it is necessary to vector across the final approach course for spacing or other…
- Chapter 4: Approaches › Approach Control
Approach Control Approach control is responsible for controlling all instrument flights operating within its area of responsibility. Approach control may serve one or more airports. Control is exercised primarily through direct pilot and controller communication and airport surveillance radar ... Prior to arriving at the initial approach fix (IAF), instructions will be received from the air route traffic control center (ARTCC) to contact approach control on a specified frequency. Where radar is approved for approach control service, it is used…
- Chapter 10: IFR Flight › Approaches › Approach to an Airport With an Operating Tower, With an Approach Control
altitude/flight levels are issued as required for spacing and separating aircraft; do not deviate from the headings issued by approach control. 4. Aircraft are normally informed when it becomes necessary to be vectored across the final approach course for spacing ... other reasons. If approach course crossing is imminent and the pilot has not been informed that the aircraft will be vectored across the final approach course, the pilot should query the controller. The pilot is not expected to turn inbound…
- Pilot/Controller Glossary › F
FINAL APPROACH COURSE.) (See FINAL APPROACH FIX.) (See FINAL APPROACH POINT.) (See SEGMENTS OF AN INSTRUMENT APPROACH PROCEDURE.) (See ICAO term FINAL APPROACH.) FINAL APPROACH POINT- The point, applicable only to a nonprecision approach with no depicted FAF (such ... airport VOR), where the aircraft is established inbound on the final approach course from the procedure turn and where the final approach descent may be commenced. The FAP serves as the FAF and identifies the beginning of the final approach…
- Chapter 4: Approaches › Stabilized Approach
This process is simplified by maintaining a constant approach speed, descent rate, vertical flight path, and configuration during the final stages of an approach. This is referred to as the stabilized approach concept. A stabilized approach is essential for safe ... turbojet operations and commercial turbojet operators must establish and use procedures that result in stabilized approaches. A stabilized approach is also strongly recommended for propeller-driven airplanes and helicopters. You should limit configuration changes at low altitudes to those changes…