AA.VI.H.S11
SkillUse runway incursion avoidance procedures, if applicable.
From the FAA library
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-5. Instrument Approach Procedure (IAP) Charts
type of equipment may be used to execute the final approach (e.g., VOR or GPS RWY 15). NOTE-This procedure identification method has changed and these procedures will be revised in the course of the normal procedure amendment process ... slash and equipment (e.g., /DME) information will be removed with future amendments. Pilots should review the procedure’s notes, planview annotations, and PBN/equipment requirements boxes to determine the capability needed to accomplish the procedure. (b) In some cases, other types…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-16. Simultaneous Close Parallel PRM Approaches and Simultaneous Offset Instrument A…
Radar monitoring will automatically be terminated when visual separation is applied, or the aircraft reports the approach lights or runway in sight or within 1 NM of the runway threshold. Final monitor controllers will not advise pilots when radar monitoring ... approaches published at a specific airport, and this section must be briefed in its entirety. Under the “Runway Specific” section, only items relative to the runway to be used for landing need be briefed…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-13. Simultaneous Approaches to Parallel Runways
Simultaneous Approaches to Parallel Runways FIG 5-4-20 Simultaneous Approaches (Approach Courses Parallel and Offset between 2.5 and 3.0 degrees) a. ATC procedures permit ILS/RNAV/GLS instrument approach operations to dual or triple parallel runway configurations. ILS/RNAV/GLS approaches to parallel ... runways are grouped into three classes: Simultaneous Dependent Approaches; Simultaneous Independent Approaches; and Simultaneous Close Parallel PRM Approaches. RNAV approach procedures that are approved for simultaneous operations require GPS as the sensor for position updating. VOR/DME, DME/DME and IRU RNAV…
- Chapter 10: IFR Flight › Approach to an Airport With an Operating Tower, With an Approach Control › Approaches to Parallel Runways
Approaches to Parallel Runways Procedures permit ILS instrument approach operations to dual or triple parallel runway configurations. A parallel approach is an ATC procedure that permits parallel ILS approach to airports with parallel runways separated by at least ... feet between centerlines. Wherever parallel approaches are in progress, pilots are informed that approaches to both runways are in use. Simultaneous approaches are permitted to runways: 1. With centerlines separated by 4,300 to 9,000 feet; 2. Equipped with…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-21. Missed Approach
provided, the pilot should conform to radar vectors when provided by ATC in lieu of the published missed approach procedure. (See FIG 5-4-31.) e. Some locations may have a preplanned alternate missed approach procedure ... event the primary NAVAID used for the missed approach procedure is unavailable. To avoid confusion, the alternate missed approach instructions are not published on the chart. However, the alternate missed approach holding pattern will be depicted on the instrument approach…
- Chapter 8: Aviation Instructor Responsibilities and Professionalism › Flight Instructor Responsibilities › Ensuring Learner Skill Set
item included in the applicable ACS/ PTS. The ACS integrates risk management and safety throughout and with supplementary appendix information. PTS lists special emphasis items. Some common items include: 1. Positive aircraft control 2. Procedures for positive ... exchange of flight controls 3. Stall and spin awareness 4. Collision avoidance 5. Wake turbulence and low-level wind turbulence and wind shear avoidance 6. Runway incursion avoidance 7. Controlled flight into terrain (CFIT) 8. Aeronautical decision-making (ADM)/risk…