AA.VII.B.K1
KnowledgeThe procedures used during a powerplant(s) failure on takeoff, the appropriate reference airspeeds, and the specific pilot actions required.
From the FAA library
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance
Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Rejected Takeoff
takeoff and climb-out should be accomplished in accordance with a standard takeoff and departure profile developed for the particular make and model airplane. [Figure 16-13] Figure 16-13. Sample takeoff and departure profile. The pilot not flying should ... call out V1. After passing V1 speed on the takeoff roll, it is no longer mandatory for the pilot flying to keep a hand on the thrust levers. The point for abort has passed, and both hands may be placed…
- Chapter 6: Takeoffs and Departure Climbs › Crosswind Takeoff › Takeoff Roll
Crosswind Takeoff While it is usually preferable to take off directly into the wind whenever possible or practical, there are many instances when circumstances or judgment indicate otherwise. Therefore, the pilot must be familiar with the principles and techniques involved ... crosswind takeoffs, as well as those for normal takeoffs. A crosswind affects the airplane during takeoff much as it does during taxiing. With this in mind, the pilot should be aware that the technique used for crosswind correction during takeoffs…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › V-Speeds
Airplane Takeoff and Climb The following information is generic in nature and, since most civilian jet airplanes require a minimum flight crew of two pilots, assumes a two-pilot crew. If any of the following information conflicts with FAA-approved ... procedures for a particular airplane, the AFM procedures take precedence. Also, if any of the following procedures differ from the FAA-approved procedures developed for use by a specific air operator and/or for use in an FAA-approved training center…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Takeoff Roll
Rolling takeoffs can also be made from the end of the runway by advancing the thrust levers from idle as the brakes are released. During the takeoff roll, the pilot flying should concentrate on directional control of the airplane. This ... propeller-driven airplane. The airplane should be maintained exactly on centerline with the wings level. This automatically aids the pilot when contending with an engine failure. If a crosswind exists, the wings should be kept level by displacing the control…
- Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb
runway is long enough or if no obstacles exist, ground effect can be used to the pilot’s advantage by using the reduced drag to improve initial acceleration. When taking off from an unsatisfactory surface, the pilot should apply ... ground run and lift-off, using ground effect as an aid, prior to attaining true flying speed. The pilot should reduce AOA to attain normal airspeed before attempting to fly out of the ground effect areas. Short-Field Takeoff…