AA.VII.E.K2
KnowledgeGo-around/rejected landing procedures with a powerplant failure.
From the FAA library
- Chapter 9: Approaches and Landings › Go-Arounds (Rejected Landings)
Arounds (Rejected Landings) A go-around is a normal maneuver that is used when approach and landing parameters deviate from expectations or when it is hazardous to continue. Situations such as air traffic control (ATC) requirements, unexpected appearance of hazards ... runway, overtaking another airplane, wind shear, wake turbulence, mechanical failure, or an unstable approach are all reasons to discontinue a landing approach. Like any other normal maneuver, the go-around should be practiced and perfected. The flight instructor should emphasize…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…
- Chapter 9: Approaches and Landings › Emergency Approaches and Landings (Simulated)
Emergency Approaches and Landings (Simulated) During dual training flights, the instructor should give simulated emergency landings by retarding the throttle and calling “simulated emergency landing.” The objective of these simulated emergency landings is to develop a pilot’s accuracy, judgment ... planning, procedures, and confidence when little or no power is available. A simulated emergency landing may be given with the airplane in any configuration. If the simulated power failure occurs while above best glide speed, the pilot allows the airplane…
- Chapter 9: Approaches and Landings › Crosswind Approach and Landing
Common Errors Common errors with forward slips to a landing: 1. Incorrect pitch adjustments that result in poor airspeed control. 2. Reacting to erroneous airspeed indications. 3. Using excess power while trying to lose altitude. 4. A slip ... same direction as any crosswind. 5. Poor glidepath control. 6. Late transition to a sideslip during landing with crosswinds. 7. Landing without the longitudinal axis parallel to runway. 8. Landing off the centerline. Crosswind Approach and Landing Most runways…
- Chapter 18: Emergency Procedures › Emergency Landings › Types of Emergency Landings
Emergency Landings This section contains information on emergency landing techniques in small fixed-wing airplanes. The guidelines that are presented apply to the more adverse terrain conditions for which no practical training is possible. The objective is to instill ... pilot the knowledge that almost any terrain can be considered “suitable” for a survivable crash landing if the pilot knows how to use the airplane structure for self-protection and the protection of passengers. Types of Emergency Landings The different…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Engine Landing › Landing Speeds
Landing Speeds As in the takeoff planning, there are certain speeds that should be taken into consideration when landing a jet airplane. The speeds are as follows: ⦁ VSO —stall speed in the landing configuration. ⦁ VREF —1.3 times the stall speed ... landing configuration. ⦁ Approach climb—the speed that guarantees adequate performance in a go-around situation with an inoperative engine. ⦁ Landing climb—the speed that guarantees adequate performance in arresting the descent and making a go-around from the final stages…