Airline Transport Pilot and Type Rating for Airplane Category › VII. Emergency Operations › Task E. Approach and Landing with a Powerplant Failure (Simulated) (AMEL, AMES)

AA.VII.E.R6

Risk management

Performing a go-around/rejected landing with a powerplant failure.

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Airplane Flying Handbook p. 9-10
Chapter 9: Approaches and Landings › Go-Arounds (Rejected Landings)
Arounds (Rejected Landings) A go-around is a normal maneuver that is used when approach and landing parameters deviate from expectations or when it is hazardous to continue. Situations such as air traffic control (ATC) requirements, unexpected appearance of hazards ... runway, overtaking another airplane, wind shear, wake turbulence, mechanical failure, or an unstable approach are all reasons to discontinue a landing approach. Like any other normal maneuver, the go-around should be practiced and perfected. The flight instructor should emphasize…
Pilot's Handbook of Aeronautical Knowledge p. 11-17
Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…
Airplane Flying Handbook p. 16-20
Chapter 16: Transition to Jet-Powered Airplanes › Jet Engine Landing › Landing Speeds
Landing Speeds As in the takeoff planning, there are certain speeds that should be taken into consideration when landing a jet airplane. The speeds are as follows: ⦁ VSO —stall speed in the landing configuration. ⦁ VREF —1.3 times the stall speed ... landing configuration. ⦁ Approach climb—the speed that guarantees adequate performance in a go-around situation with an inoperative engine. ⦁ Landing climb—the speed that guarantees adequate performance in arresting the descent and making a go-around from the final stages…
Airplane Flying Handbook p. 9-28
Chapter 9: Approaches and Landings › Emergency Approaches and Landings (Simulated)
Emergency Approaches and Landings (Simulated) During dual training flights, the instructor should give simulated emergency landings by retarding the throttle and calling “simulated emergency landing.” The objective of these simulated emergency landings is to develop a pilot’s accuracy, judgment ... planning, procedures, and confidence when little or no power is available. A simulated emergency landing may be given with the airplane in any configuration. If the simulated power failure occurs while above best glide speed, the pilot allows the airplane…
Seaplane, Skiplane, and Float/Ski Equipped Helicopter Operations Handbook p. 7-7
LANDINGS
LANDINGS Landing a skiplane is easy compared to landing with wheels; however, for off-airport landings, extra precautions are necessary. Be careful in choosing a landing site. Before landing, evaluate the site to be sure a safe departure will ... possible. Upon arriving at a prospective landing site, a pass should be made over the landing area to determine landing direction, and to determine if a safe approach and landing can be completed. A trial landing should be accomplished…