AI.II.C.K2

From the FAA library

• Aeronautical Information Manualp. 5-2-2
  Chapter 5. Air Traffic Procedures › Section 2. Departure Procedures › 5-2-5. Line Up and Wait (LUAW)

  Parts 91, 121, 125, and 135 Flightcrew Procedures during Taxi Operations. d. Situational awareness during line up and wait operations is enhanced by monitoring ATC instructions/clearances issued to other aircraft. Pilots should listen carefully if another aircraft is on frequency ... look for aircraft crossing the runway, on final approach, or landing roll (including intersecting runways) prior to and while taxiing onto the runway. ATC should be contacted anytime there is a concern about a potential conflict or clarity is needed…

• Aeronautical Information Manualp. 4-3-24
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing

  When issuing taxi instructions to any point other than an assigned takeoff runway, ATC will specify the point to taxi to, issue taxi instructions, and state any hold short instructions or runway crossing clearances if the taxi route will cross ... runway. NOTEATC is required to obtain a readback from the pilot of all runway hold short instructions. 8. If a pilot is expected to hold short of a runway approach/departure (Runway XX APPCH/Runway XX DEP) hold area or ILS holding…

• Pilot's Handbook of Aeronautical Knowledgep. 14-31
  Chapter 14: Airport Operations › Collision Avoidance › Runway Incursion Avoidance

  Review airport layouts as part of preflight planning, before descending to land and while taxiing, as needed. • Know airport signage. • Review NOTAM for information on runway/ taxiway closures and construction areas. • Request progressive taxi instructions from ATC when unsure ... taxi route. • Check for traffic before crossing any runway hold line and before entering a taxiway. • Turn on aircraft lights and the rotating beacon or strobe lights while taxing. • When landing, clear the active runway as soon as possible, then…

• Aeronautical Information Manualp. 4-3-28
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing

  operating control tower, pilots should not stop or reverse course on the runway without first obtaining ATC approval. b. Taxi clear of the runway unless otherwise directed by ATC. An aircraft is considered clear of the runway when all parts ... there are no restrictions to its continued movement beyond the runway holding position markings. In the absence of ATC instructions, the pilot is expected to taxi clear of the landing runway by taxiing beyond the runway holding position markings associated…

• Pilot's Handbook of Aeronautical Knowledgep. 14-34
  Chapter 14: Airport Operations › Collision Avoidance › ATC Instructions—“Line Up and Wait” (LUAW)

  Instructions—“Line Up and Wait” (LUAW) ATC now uses the “line up and wait” (LUAW) instruction when a takeoff clearance cannot be issued immediately due to traffic or other reasons. The words “line up and wait” have replaced “position ... hold” in directing you to taxi onto a runway and await takeoff clearance. An ATC instruction to “line up and wait” is not a clearance for takeoff. It is only a clearance to enter the runway and hold in position…