AI.VII.A.S15
SkillMaintain directional control and proper wind-drift correction throughout takeoff and climb.
From the FAA library
- Chapter 6: Takeoffs and Departure Climbs › Soft/Rough-Field Takeoff and Climb › Initial Climb
Initial Climb After a positive rate of climb is established, and the airplane has accelerated to VY, the pilot should retract the landing gear and flaps, if equipped. If departing from an airstrip with wet snow or slush ... takeoff surface, the gear should not be retracted immediately so that any wet snow or slush can be air-dried. In the event an obstacle needs to be cleared after a soft-field takeoff, the pilot should perform the climb…
- Chapter 6: Takeoffs and Departure Climbs › Crosswind Takeoff › Takeoff Roll
Crosswind Takeoff While it is usually preferable to take off directly into the wind whenever possible or practical, there are many instances when circumstances or judgment indicate otherwise. Therefore, the pilot must be familiar with the principles and techniques involved ... crosswind takeoffs, as well as those for normal takeoffs. A crosswind affects the airplane during takeoff much as it does during taxiing. With this in mind, the pilot should be aware that the technique used for crosswind correction during takeoffs…
- Chapter 3: Basic Flight Maneuvers › Climbs and Climbing Turns
Normal climb speed is generally higher than the airplane’s best rate of climb. The additional airspeed provides for better engine cooling, greater control authority, and better visibility over the nose of the airplane. Normal climb is sometimes referred ... cruise climb. ⦁ Best rate of climb (VY)—produces the most altitude gained over a given amount of time. This airspeed is typically used when initially departing a runway without obstructions until it is safe to transition to a normal…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance
Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…
- Chapter 6: Takeoffs and Departure Climbs › Normal Takeoff › Initial Climb
airspeed indicator should be used only as a check to determine if the attitude is correct. After the recommended climb airspeed has been established and a safe maneuvering altitude has been reached, the pilot should adjust the power ... recommended climb setting and trim the airplane to relieve the control pressures. This makes it easier to hold a constant attitude and airspeed. During initial climb, it is important that the takeoff path remain aligned with the runway to avoid…
- Chapter 6: Takeoffs and Departure Climbs › Prior to Takeoff
When operating from a towered airport, pilots need to contact the tower operator and receive a takeoff clearance before taxiing onto the active runway. Taking off immediately behind another aircraft, particularly a large and heavy transport airplane, creates the risk ... wake turbulence encounter, and a possible loss of control. However, if an immediate takeoff behind a large heavy aircraft is necessary, the pilot should plan to minimize the chances of flying through an aircraft’s wake turbulence by avoiding…